A mixer can with an electric brake application. The main axle of the mixer, which is installed on the main axle of the mixer, is directly driven by the output axle of the motor decelerator. The more finer the feed, the longer the motor-reducing box runs. So how do you make the feed? The feed mixer is one of the feed makers that mixs the different ingredients. How can the market demand for meat products be met? In addition to the entry point, there is another way to feed. The following is a description of how this structure worked in the course of the work and how it was managed to maintain the devices later in use. The size of the mix is different because the requirements for feed vary from animal to animal. The overall workflow is probably a mixture of raw materials into the mixing box after simple cutting through the input funnel. In addition to mixing, mixing can cut some large uncut materials at this timeGeared motorContinuous work is required to meet the operational requirements of the equipment. So more than a third of the food is from the outdoors, unlike the rest. Almost all of the food in the trap is from man-made feed. The feed after mixing will be exported through the source. One of the two main areas of interest to the manufacturer, using an electric decelerator on this feed mixer, is the need to select the appropriate electric decelerator on the basis of the load at the time of selection, and it is usually possible to select a slightly larger electric decelerator to be used on such equipment。