1. 5 kwreducing machines up to 2. 8, at whichreducing models should be selected? In such a broad range of parameters to select a type that fits the use of areducing machine, the parameters must be limited before one of the many models is selected for use. yesDouble- power reduction unitIn the combined parameters, the range of output rotations that can be formed ranges from 0. 59 to 681 per minute, the range of reduction ratios ranges from 4. 16 to 2427 and the range of output twists ranges from 21nm to 21800nm. When different equipment chooses to usereducing machines, what we need to consider is the detailed parameters requirements of the equipment at the time it is used, which may be the parameters that can be found in the direct sample or the parameters that need to be calculated for conversion. In such cases we need to match the requirements of the actual parameters. The above models can match the 1. 5-kw power, so in this case we can look at the detailed parameters. This is the type ofreducing machine selected according to the user ' s parameters. The factors that we need to take into account when different devices are using a moving device are still a lot of things, so what we need in this case is a matching drive that matches the actual situation. which one of thereducing models can be used at this timeGearbocWhat are the types ofreducing motors that can be matched at this time?

In the user ' s parameter requirements, there is a clear use requirement that the output of thereducing motor be rotated to a rate of 2. 8 per minute, and does the list of parameters at this time coincide with 2. 8 per minute? At this point, we look at the list of parameters, which does not exactly turn 2. 8 per minute, but which is closer to 2. 9 per minute and 2. 7 per minute. If you choose 2. 7 per minute, then the output twist is 4880Geared motorFf97r57 deflator. The user requirements include a clear electrical power as well as the type ofreducing machine, and the 2. 8 rotation achieved after thereducing combination. On the selected sample, we can see a matching ff27reducing, ff37reducing, f47reducing, fs7, ff67reducing, ff77reducing, ff87reducing, ff97, ff107reducing, ff87r57reducing, ff107, ff107 r77reducing, ff127 r77reducing, ff157 r97. If 2. 9 turns are selected, the output twister at this time is 4440nm, the reduction ratio is 489, the axle direction load is 57,500n, and the correspondingreducing motor type is ff107r77. What should be done in such a case? At this point,matching can be used. In the selection of a user a short time ago, his request was to use a ff-type reduction machine to match the 1. 5 kw power to 2. 8 turns. The different equipment, on the other hand, is used in such a way that the actual subject matter is taken into account by a large number of users when choosing thereducing machine because of different loads and different parameters requirements. In other words, which one of the 2. 9 turns per minute can be usedSpeed-down powerIt is also possible to use the group of 2.7 turn-minutes, but to match the use with a 1.5 KW variable frequency power. But in either case, as many parameters as possible are available, so that the electric andreducing machines are selected with greater ease and the correct choice of the corresponding model and of the verification parameters. http://boserlgearreducer.com/product/list-ffxiiejiansuji-cn.html