How do you choose areducing one-to-49 machine on a curve? In such a case, the functional parameters of the equipment would have to be re-established in order to determine the electrical power used on the equipment as well as thereducing model. So man-made is not easy to handle, and in this case a mechanical device is used to do such a job. On the other hand, the power engine on the device uses the server, which connects to the reduction machineGearbocthe upper gear of the output axis and the lower gear rod of the rotor of the two power wheels. at the time of use, on the basis of the given curve radius, the offsetting wheel moves to the given position under the driver of the compressor slider, and the rolling of the compressor corresponds to the convex radius and can be controlled by plc. however, in the course of his request, there were no detailed parameters required, and it was therefore difficult to select the corresponding electric andreducing models for matching use to satisfy his convection. this is the user's higher-precision curve machine. high-precision contour machines, including curved workstations, shearing workstations, power wheels, clamps, pressurized wheels, hydraulic shears and drive unitsReducer+MotorWait. Encoders are installed on the pressurized wheel, which are co-axis with the pressurized wheel axis, both of which are synchronized (angular equal). You can communicate with the expresser-select technical staff, and then the technicians will select the appropriate model for use on the corresponding equipment, as requested by you

When the user selects the power for his convection machineAn umbrella gear-reducing machineAt the same time, his request was to use the 1:49 decelerator for use on his rotor, but it was not certain what the detailed parameters were, so it was not easy to choose to use the corresponding electric power and the decelerator model to match his equipment length. During the processing of some steel plates, they are often required to roll different thicknesss, and different sizes of the plates into cylinders, for use or for transport. The function of the compressor is to control the convection of the steel, which is used to regulate the convection radius by insulation and exit of the composting wheel, and to ensure the accuracy of the flow of the convection cycle and the accuracy of the convection radius by servulating the motor. During the convection, the vibrations of the power wheel-driven electric motor, the telegraphic F47 decelerator and the slippage of the steel on the power wheel of type 1 do not affect the millimetre accuracy of the steel, thus ensuring the correct measurement of the convection length. However, in the process of collating these steel plates, greater effort is often required to achieve such a process. There are two tight-wheeled and one pressurized slider on the side of the curved workstation, each of which is fitted with a bar structure and slider, with a tight and pressurized wheel on the side of the slider, and two power wheels on the side of the bending workstation, fixed on the axis of the power wheel, a straight slider on the side of the cutting workstation, and a hydraulic shearing device on the side of the line. It was not easy to determine a model in a previous user's request to use a 1-to-49 brake on his device, because the parameters were not consistent enough to select the corresponding oneGeared motorthe model is used. the voltage wheel slides the engine uses the server, which rotates through the screw of the chain-enabled silk bar structure, driving the compressor to and from it. so let's look at some details of the equipment. power-wheel-drive power units, when used to serve them, can guarantee the accuracy of the steel walk, a progressive dynamic response and, to a certain extent, the efficiency of the curvers. so let's look at some details of the equipment that the user has. http://boserlgearreducer.com/product/list-rxxiilijiansuji-cn.html