How can an umbrella gear-reducing machine 1:57 be used on a bulk machine? Since users do not limit the type ofreducing machine, gear-reducing machines can be used at this time as wellSnail scaldingMatch as long as his functional parameters are adequate for actual use requirements. During the discharge of some loosed materials, such as cement, stone powder, dry powder sand or food, some would go directly to a storage site to unload the material, while others would opt for bulk machines to unload the material. Users ' devices include the installation of tablets, motor brakes and mini-madas, among others. In the user selection process, his request was to use a 57-to-peer decelerator to use on his bulker, but it was not easy to select the corresponding electric decelerator model with only one functional parameter, so it was necessary to know some of the operation of his equipment before choosing the corresponding electric power and decelerator model. in the course of the material, the material enters the interior of the outside canned vehicle through a feed tube, a stretcher and a bulkhead, the dust pump is connected through the flange to the external dust removal equipment, the dust inside the material is extracted from the inside of the feeder via a dust removal tube, the inner pore of the filter is less than the diameter of the material, the dust is separated from the material by a filter and thereducing machine is opened while the material is down, the rvreducing machine is rotated through the wheel-enhanced steverator in the input tube, the revolving animal is used to use the steverage plate to prevent the material from being contained in the input tube, and the material from being plugged into the materialMotor gearedThe panels are rotated on the filters by the power, avoiding the material being blocked on the right side of the filters。

In the selection of a user a short time ago, he needed a one-to-fifty-sevenreducing machine to be used on his bulk, at a time when he didn't know how large the electric and thereducing model would match the operation of his equipment, so he consultedGeared motorThe selected technical staff provided him with details of the selection and recommended the corresponding reduction model. The inner side of the connector sets up a feed tube that is attached to the stack, and the left end of the feeder pipe is connected to the dust pump, and a filter is installed inside the pump. Driven by power-driven motor-reducing machines, the orderly conduct of different components leads to the delivery of materials. The driver is on the right side of the bearing board, the output end of the driver is connected to the brake and is fixed to the gear, and both sides of the gear are connected to the gear, and the right side of the gear is welded with a qualifying bar, the left side of the gear is welded with a connection pole and the left end of the connection pole is surrounded by a leash. In condensed terms, in the course of his work, when using the bulk, both the front-drive s series decelerators and the mini-madas worked in well-developed technologies in the current context, turning on the motors, driving the motor-drivers to rotate through another set of gear-driving synchronous clockwises, and thus to rotate the connecting poles on the gears. Here are some details and the operational requirements of his equipment during the selection process. Let's take a look at some details of the user's equipment. but there are no detailed parameters, so it's not easy to chooseAn umbrella gear-reducing machinethe model is matched, and further communication between the expresser selection technical staff and the user is still required to verify the detailed operating requirements, and then calculate the functional parameters to select the appropriate motor decelerator model for use. these are some details of the user ' s bulk machine. http://boserlgearreducer.com/product/list-zhiajiansuji-cn.html