How can a snailreducing machine be used on a Magnetic Selector? There are two modulation buttons on the varianter that can control the of output of the gear-reducing or snail-reducing machines by means of FM. The output boxes are divided into two boxes for magnetic and non-magnetic materials. This magnetic selection process is designed to feed the material from the feed, activate the vibrating power, and drive it through the vibrating powerGeared motorIn the process of boosting the vibrating sieve to spread the material evenly, into the lower cauldron, and then into a circular magnet on average for magnetic selection, the dust in the material is shocked and co-activated by the wind mask, which is excreted from the dust removal vent through the wind mask. In the process of separation of magnetic and non-magnetic materials, the frequency of the variants needs to be adjusted to the different proportions of the magnetic selection material in the material, thus giving the magnetic selection a higher purity. There are shock-giving devices in the upper part of the magnetograph's lower cavity, including vibrating sieves and vibrating electrics installed at the lower part of the vibration sieves, with feed entrances open on the upper part of the vibration sieves and shock-sieves fixed on the frame. In circular magnets, magnetic material is combined with centrifugal, gravitational and magnetic force, adsorbed to the inner wall of the circular magnet and continuously transmitted out into the magnetic material outlet。

Users ' magnetographers, including feed outlets, dust vents, wind masks, vibrating machines, circular magnetsThree-phase variant powerreducing machine, magnetic material outlet, rack, non-magnetic material outlet, vibrating sieve panel, substrate, etc. Different brakes are different in terms of function. In other words, in the circumstances, it is not possible to select a detailed reduction model for matching use to meet the detailed requirements of his equipment. Non-magnetic materials are also constantly exported and fed into the non-magnetic material outlet when they are not subject to a direct-angle decelerator of magnetic force and are only combined with gravity and centrifugal force. (c) the main axis of the machine, which is attached to the k107 decelerator, and the central axis of the circular magnet, are fitted on the circular magnet, and the outer end of the transformer is attached to the slowing machine, which is attached to the frame. In the selection of a user a short time ago, his request was to use the 1:65 reduction machine, but how much power should it be? What are the topics to consider in matching? What environmental factors need to be taken into account when the magnetograph selects the corresponding electric andreducing model? Some details of the user’s equipment are given below. you can letAn umbrella gear-reducing machineSelect technical staff for you

When the user selects his magnetographer for the electric machine and thereducing machine model, the user provides areducing machine ratio of 65, but a great number of umbrella gear-reducing machines can fight 65 after the model of the power mix. In some powdered or granular materials, there are times when it is necessary to select some of the substances in these materials, as if they were needed in the recovery of titanium ore, at which point a device called the Magnetographer performed his role. Then let's look at some details of the user's equipment, and then see how to choose the appropriate model for matching use. Sealed lead winds and dust removal vents are present on top of the shock material device. These are some of the details of the user ' s equipment, in which case it is not easy to select the corresponding power of the power of the power and the type of the reduction machine. If it's more efficient to do so, then you can chooseMotor geared, and if self-locking is required in the course of the operation, choose to use snail snails for a matching use. http://boserlgearreducer.com/product/list-wolunwomenjiansuji-cn.html