How does a second-stagereducing machine 1:70 work on a mine machine? You can also choose to download a sample of the type ofreducing machine, and look at the details of the size of the parameters in the user's selection, and he can only ask for a reduction of 70, and a reduction of 70, which is more than the size of its model, which is a few, than using 1.5 kilowatts to match the gear-reducing machineGeared motorIt is difficult to choose a fixed combination when there is a wide range of matches, so we need to know - some of the operation of the mine machinery of the next user, and then to select a detailed model. These parameters were to be provided by the user, who, as a technical employee of the type chosen for thereducing machine, was not aware of the detailed velocity requirements, or load capacity, set by the user when designing the machine. YesLow-number, big-twirlIn the process of screening, the right side of the driver ' s sift is treated with a hose, the right and right side of the sift is connected to the scavenger by a fixed plate, a pump is attached to the scavenger, a water pump is attached to the scavenger on the right side of the scavenger, a water vent is attached to the right side of the scavenger, a scavenger is placed on the right side of the scavenger, a water pump is attached to the scavenger and a water pump is installed on the right side of the scavenger。

A few days ago, in the selection of a user, he needed an electric brake machine that could be used by his mine machine, and he set the reduction rate at 70, and he didn't know how muchPower-reducing machineThe model combinations produce 70-to-peer parameters, so he consulted ourreducing machine selection technologists to provide him with technical support, or related advice, and in that case, what would you do? Uninformedly, look at how some of the devices on the user equipment are connected. These are some of the details of the user equipment, but in such a case the model cannot be determined, so our slowing machine selection technologist will follow up further with the user, then after the user has identified the parameters, will give the user the right type ofreducing device and will provide the user with the corresponding size chart and parameters to check the information. In the case of ores or some coal mining, which can be used in many different ore machines, there is also a difference in the power required for different ore machines to be used. the user ' s mine machinery consists of a cleaning cavity, a filter at the top of the cleaning cavity, which allows for the smoothing of coal, a link axis at the inside of the cavity, a power-driven brake on the upper side of the cavity, and areducing machine for the r series of drivers on the upper side of the cavity, by drivingMotor gearedenabling axle and filters to rotate so that equipment can rotate and centrifugal processing can facilitate the screening of coal. the user is mainly using a hard-temperator to drive his purge cavity and sifter, and what we need to know is some of the parameters of this sift, which is as much as one minute, and how much load he needs to drive to run in the process. http://boserlgearreducer.com/product/list-saxiliejiansuji-cn.html