How can one of the one-to-73 brakes be used on a wood peeler? The lumber-skinner operation is simple, with electric-driven blades rolling throughGeared motorAnd a chain of wheels leads to the rolling of incoming and outgoing materials, where skind wood is placed in the drop-in and roll-in, which is adjusted to the control pole, which binds the wood into the plate through a chain of poles, and which adjusts the gap between the roll-in and the log with a pedal, which is led by a belt in the middle of the four blade-drive bearing wheels, while the blade is able to swing in a spring and is able to swing in the axis under the butterfly springs and steel ball, so that the blade on the back plate of the wood enters the plate with a springing and a rolling of the blade to the point of slitting. Here's the details. The knife is placed on the front end of the blade, the knife is replaced, as needed, with a horizontal blade on the blade, a vertical trough to reduce cut resistance and wood damage, a knife rod is placed on the blade with a pole, five blades are attached to the blade, the blade is connected to the pole with a steel ball, the blade is tied to the blade's axle, and the butterfly spring is placed on the second side of the blade and on the axe. At this point, his request was to use a 73-to--reducing device, and since he did not need to be so fast at, he could be satisfied with a 4-polar power plant. When the device is selected, you can download a sample of the slowing machine or a relevant selection manual, calculate the parameters and then convert them toThree-hundred-thirty-eight-fiveduring the initial processing of the material, the different material was treated differently, and in the selection of a user a short time ago, he needed an electric decelerator to drive his wood peeler to run, at a time when he did not know that it would be more appropriate for his equipment to run using a unique combination of the motor decelerator, so he found a boserl decelerator technologist to select a suitable model for his equipment to operate。

If you don't know how to choose a model, you can consult the boserlreducing techs so that they can select the icaron-like motor-reducing model to match your equipment master to the user-selectElectricreducing machine - body machineThe skin-skinner was driven to operate without knowing how to match a 73-to-73-square-reducing machine in the circumstances, so he would have preferred to have thereducing machine-selecting technologist select his equipment. A power control box is installed on the rack, which is accompanied by a walker, an electric and areducing machine on the bottom of the rack, a roll-on and a roll-out, which is mounted on the upper and lower sides of the plate through a chain of poles, and is fixed on the racks through the bearings, four blade-drives, which are mounted on the racks, which are placed in the middle of the four load bearings, a spring between the roll-out and the bearings of the two entry and exit materials, a wire that is linked to the blade, a stubble, a chain of power-reducing axes, which is attached to the wheel of thereducing machine, which is linked through the chain to the conveyor bearings that are mounted on the entry and exit material, and a blade-drive is made up of blade poles, blades, blades, axes, butterfly blades and steel balls. but in these circumstances, it is not clear what the detailed parameters are, so in these circumstances it is not easy to define the detailed modelServo motor reducerin the case of the selected type, look at the requirement between the belt and the blade plate of the user, and in this case match the correspondingreducing model and the power of the electric power to make his wood peeler work. look at the details of the user's equipment without any other parameter being required. the wood peeler consists of a rack, an electric machine, a control pole, a roll-in and out, a knife plate, a knife plate bearing wheel, a reduction machine, a chain wheel, etc. http://boserlgearreducer.com/product/list-safxiiejiansuji-cn.html