4. 9kw/4900w type of motor should be equipped with a type freducing machine. in a recent device-designing process, his request was to use oneType f deceleratorThe driver was used, and in this case his request was to use 4. 9 kw powerType f deceleratorWe'll use it on his deviceFSeries slow downIt's more appropriate to combine the models. Let's look at the user's plastic particle machineType f deceleratorSelect some of the situations. This is the user's deviceType f deceleratorSome details. The use of plastic granule cutters is very extensive and is mainly used for the recycling of used plastics and the production of new plastics. It was not easy to select a detailed model to match his equipment in the absence of additional parameter requirements. A plastic-cutting machine is a device for the recycling of used plastics, which can cut them into small particles and then process them into new plastics. Let's take a look at some details of the user's equipment。

The particle-cutting components of the environmentally friendly plastic cutter include, for example, the cutting of plastics by the cutting of a particle generator, a mix of axes and cutting blades, the setting of springs in the base, which reduce the impact of shock on the box during a rolling exercise, as well as the handling and dust tank, which is connected to the box, which is connected to the upper end of the treatment box with a feeder, which is connected with a support component and a support bar, which is supported by an electrical device, which is supported by a support plate, a support plate and a treatment box, a support pole for a fixed connection on the support panel, a support kit for a support pole, an installation gate on the support box, a more attached panel at the mouth, which can be installed on the support box, which can be fitted to the support panel, which can be fitted to the support panel, while at the same time being supported by a support pole and a support plate, which can be easily maintained for the reduction machineType fGeared motorSets a protection seat between the support bar, which includes a rolling pole, a rolling pole connected to the output end of the boserl generator, a rolling pole connected to the support bar, a scroll pole connected to the plate with a protection panel, a support bar with a scrolling slot for rolling poles, throughType f deceleratorWhen used, the support box is opened to the panel, the power is installed in the installation box, and the boserl'sreducing machine is set at 90 degrees, and the winder is installed in a vacuum tank with a fixed plate and block, when the bottom and brake wheel are moved to the required position, and the four brake wheels are fixedType fGeared motorComputers and start-ups allow the electric press to scroll the shield through the co-operation of the rolling pole and the connector to facilitate the entry of the cut-off plastic into the plume, while the co-operation of the slurry spring and scrollbars allows the block to roll inside the treatment box and does not hinder the plastic feed, thus facilitating progress in the environmental protection of the plastic cutter when it is working with the plastic。

In the user's selection process, his request was to use 4900 w in the f seriesGearbocWe'll use it in combination, and in this case, how much power should be supplied andType f deceleratorThe model would be more appropriate. I don't know. You can consult the boserl technologist for your choice. but there is no detailed parameter requirement in the above-mentioned parameter requirements, so it is not easy to select a detailed model for matching use, and at this time the sample of the selected type matches the 4900 w powerType f deceleratorThe models are F57, F67, F77, F87, F97, F107 and some combinations can be used in combination. http://boserlgearreducer.com/product/list-fxiliijiansuji-cn.html