How do you choose to match the brakes with a big-number reduction machine with a load of 1 ton for the equipment? When using the parameters of 20. 25 ratio at this time, the corresponding output velocity is 73 per minute, the output traverse is 98onm, the axle direction load is 18400 n, and the corresponding large-scale ratio-reducing model is kaf77. At this point, the range of the output rotation is between 3. 4 and 203, and the range of the output twist is between 350 and 19300nm, and the range of the deceleration ratio is between 7. 24 and 434. The output rectangulation of the electric power obtained by calculation was 52. 6nm, and the power of the recalculation was approximately 7. 7 kw. The above model is enough to match 7. 5 kwTurn frequency brakes slowing downModel. In the case of currently available parameters, let's calculate the power of the power of the electric power, and then select a detailed matching model to provide the user with the selected sample parameters of the high-rate reduction machine。

In different equipment, the choice of different models for matching uses is required because of different parameters, and in so doing we can consider the detailed parameters requirements of the equipment before selecting the corresponding device for matching use. We've chosen the 1,400-turner parameter for the 4p power, and if the load is 1 ton, we've chosen to calculate the power of the electric power using the parameters of 1,000 nm. if your device needs to choose the corresponding gearGeared motor, you can choose to consult the boserl-size-size-size-size-size-size-size-size-size-size-size-size-size-size-size-fits-all technicians. There are no parameters of exactly 20-to- 20 in the sample at this time, but there are relatively close parameters of 20. 25, which is not significantly different from what is actually done at this time, since the three-symmetric machine parameters were used in matching calculations. This is some of the large-rate-rate-reducing machine models that match 7. 5 kw with the kaf-type large-rate-rate-reducing machine and the corresponding large-rate-reducing machine parameters. In the selection of a user a short time ago, his equipment required a load of 1 ton, and he wanted to select a set of drives for use, at which point he had a clear use requirement. With this matching, there are more output parameters for the large-numberreducing machines that can be formed during matching. In this match, and in the parameters that have been formed, we need to know a combination of a 20-to--20-to-out output deceleration. He wants to use a kaf-rater to match a 20-to-cent cut-off for the brakes. How much power should he choose to match? is there anything on the sample that just fits his requirementsBig-rate slow-down machineHow about this?

Of the user-selected parameter requirements, there are three clear parameter requirements, at which point the requirement is to use a large kaf-typereducing machine, which uses a large ratio-reducing machine, and to provide two parameters for the corresponding large ratio-reducing machine, one carrying 1 ton and one choosing to use a 20-to-peer rate-reducing ratio. So let's see if we can match the 7. 5-kw brakes to the corresponding parametrics of the large-scalereducing machine combination. The kaf models that match the 7. 5 kw's high--downer sample at this time are: kaf77, kaf87, kaf97, kaf107An umbrella gear-reducing machineKAF127, KAF127f87, and KAF157RF97. http://boserlgearreducer.com/product/list-kafxilijiansuji-cn.html