A set of failure treatments for the two-polarreducing machines of the shield helix transmitter. The basic working principle of the shield is that the steel component of a cylindrical column excavates the soil along the forward side of the cavity axis. The analysis thought it was because of the snailA two-polar slowing machineHigh-, high pressure in the case, helix rings andSpiral cone gear deceleratorThe box's sealed up, causing the groceries to enterA two-polar slowing machineAnd when you open your breath, there's oil coming out. The helix drive is mainly one power and oneA two-polar slowing machineComposition, the driver-driven excavator, which will dig into the earth's silo and carry the dust into the pipeline of the helix, and then into the excavator. Open the snailA two-polar slowing machineThere's no more lubricating oil down there, and there's a lot of oil under it, and..A two-polar slowing machineThe fever is severe. The shell of the cylindrical component, the shield, acts as a temporary support for the unlined parts of the excavated cavity, under pressure from the surrounding layer. First, every shiftA two-polar slowing machine(b) body infestation and snail grinding, excretion of the oil from the tank, injection into the diesel-cleaning tank, and re-adding of gear oil after clean-up; The second is to extract the hydraulic fluid from the hydraulic tank for the oil test and monitor entryLow-turn reduction machine(b) Whether the slag, which enters the motor through a low- large-twirling motor output axis, is exposed to damage caused by the entire hydraulic system of the shield to ensure the safety of the hydraulic system of the shield。

Emergency treatment: Due to the tight construction schedule and the potential for a slurry surge from the repair in the vortex transporter hole, we have taken the following measures at different stages of the excavation work, depending on the level of damage to the drive: 1. Oil exchange inspection. In day-to-day security, helix transmitters were foundBipolarGeared motorAn electric setThere was oily mud coming out of the mouth of the breath, and it stopped for immediate inspection, opened the respirator and found it full of oily mud. 2 Decompression: when the shield is dug inA two-polar slowing machineBreathe open to avoid oil spills due to excessive internal pressure in the box. The excavated slag from the head blade of the shield was stored in the excavator ' s head, which was to be excavated from the excavated into the scaffold and transported outside the work of the scaffold. It's a bad working conditionA two-polar slowing machineThe plant often fails in general and is described in terms of emergency treatment for some of the failures in general. The back of the wheel-axis drive is fixed by a slide bearing, supported by floating in the front of the earth end, welding of a real earth shell with a grinding alloy bar and welding of hard alloy blocks along the blades of the spiral. Operation of the shield to dig in in a normal pattern to avoid overstretching and scavengingServo motor reducerthe interior, which causes a sealing ring, accelerates the wear and wear of the slide bearings, and reduces the back pressure of the screw transporter before the door of the helix transporter's cabin is closed upon completion of each round. http://boserlgearreducer.com/product/list-saxiliejiansuji-cn.html