How do you choose a 29-minute low-turner? In the selection process of one user a short time ago, his request was to use an electric decelerator on his coal-selector, at a time when he did not know how large the electrics were chosen and how much thereducing machines combined could satisfy some of the detailed requirements of his equipment. What is needed for his coal machine to run 29 turns per minute, and in such a case how many models to match? Let's look at the coal machine todayGear motorsChoose some details. Based on user descriptions, only one parameter requires that a detailed model cannot be selected for matching, so it is not easy to select a detailed model. To screen the top of the coal machine, which has a cascading cascading cascading pyre and a fixed seat on the bottom of the casket, which is supported by a support pole and which is supported by a fixed seat on the bottom of the pole, which is equipped with an installed frame and a fixed frame on both sides, which is attached to the cylinder by a fixed frame, which is equipped with a vibrating transmission device on the side with a vibrating transmission device and a connection between the vibrating transmission device and the mounting frame, which is set up in three groups and placed in an average order, and which is equipped with three different scavengers from the top to the bottom, which are connected to the fixtures on the frame and will require, when used, a screening of the coal from the input kit to the frame, which will activate the vibration conveyor. If you choose to use a low--reducing machine to match it, it'll be a good 29-turner, but if you determine the power of the power, then you can..Geared motorThe model is confirmed. Coal is a non-renewable resource that needs to be addressed in a taxonomy after exploitation. Different types of specifications are treated in different ways. This is some of the cases where the user ' s equipment operates with areducing device。

When the user chooses his deviceA low-turnerAt the time of the model, he had a parameter that required the use of an output rotation of 29, so could this parameter require the choice of a detailed model for matching use? So let's take a look at the user's equipment, see how big it is to meet the user's actual needs. The details require a detailed analysis, and you can consult an electrified technologist who can select a suitable model for your equipment. with a screwdriver on top of the screw, with a low-regulatingreducing engine on top, a power-out end of theregulator fixed to the screw, a slider on the surface and a thread between the slider and the screw, a second gearer on the lower side of the slider and a fixed link between the slider and the slider through the bolts on the second end of the engine, a plume axis on the power-out end of the second and a pressure bar on the side, between the press and the sifter's netGear with motorthe power output end is connected, the propeller rolls up, the slider on the screw surface is moved at the same level as the slider surface is moved at the same time as the second engine at the bottom of the slider is activated, the plume is rotated, the axle surface is set with a pressurized pole that corresponds to the scavenger hole, the plume is driven by the plume to interact with the scavenger hole, the plume is dredged, the scavenger is scavengered, the scavenger is scavengered, the screening efficiency is improved, the scavenger is installed inside the fixed seat is installed and the pole is plugged in the scavenger is attached to the installed cell, the scavengers inside the scavengers are attached to each other, the scavengers are connected to each other, the scavengers are connected to each other to the support pole, and the sound transfer is improved. http://boserlgearreducer.com/product/list-sfxiliejiansuji-cn.html