Why does a textile machine's axle-reducing machine reach an output of 1,000 turns per minute? Thereducing machine is between 1 and 5 and the output is not much of a twist, so if you have to choose this oneThrough-hole shaft reducerIf you match it, then you have to be careful whether your equipment is adequate for the rectangular requirements, because his overall rectangles are not big. In the textile industry, where a wide variety of equipment is used in different processes, how should the corresponding equipment be selected for use in the process? How do you choose the corresponding power drive on the equipment? In this case, let's use a user case to say how a textile machine should, in the course of its use, choose the corresponding electric power andreducing machine for the equipment. It's like the only one with a straight-angled snail snail in series s, and he can do it with an output turner of 206 per minute, which is not enough for a s-roller if the output turns. On the sample of the type of b0serl brakes, it can be seen what the internal layout of the brakes is, comparing the differences between them with other types of brakes. So the choice is to use rx-type or rxf-type. since this is one of the four series of slowdowns that can be achieved at 1,000 rotations per minute or more, the two series ofreducing machines can be expected to be adequateMotor gearedOr even snailreducing machines do not meet this requirement。

Some equipment requires a gear-reducing or snail-reducing machine to reach a given parameter, as if the output was 100 or 1,000, and the corresponding model chosen for the differentreducing functional parameters is different, so the parameters of the equipment need to be understood at the time of use and then matched with the corresponding electric-reducing unit. But as..Three-phase variant powerreducing machineIn the case of the manufacturer, if your output twister needs are smaller and the is larger, then you can choose to use the reduction machine to match it. For some equipment, the requirement for output is relatively high, as is the requirement for output of 1,000 per minute, which is not met by a normal type ofreducing machine when the output requirement is so high. The user's request is to use the rx-typereducing machine in the same axle slasher to match it to about 1,000 turns, and then why does thereducing machine have an output rate of about 1,000 turns when it matches? What about the other brakes? What about some of the rx-type brakes and how he's different from other types of brakes? In the process of selecting the use of an electricreducing machine, the combination of an electricreducing machine may vary due to the equipment factor, in which case the choice of the corresponding electric power and thereducing machine are based on the parameters of the equipment. so why does thisdown work at a professional output rateGeared motorbut it's not. because there's a big difference between the internal structure of thisreducing machine and otherreducing machines, it's mainly his rags that differ. http://boserlgearreducer.com/product/list-tongzhoujiansuji-cn.html