Characteristics of a snail snailer, Frank connector. The mats shall be soft, unageable, unbreakable, wrinkled, scratched, etc. The first four are described in detail below: welding only to the outer layer and not to the inner layer; and, generally, to the low- and medium-pressure pipe, which has a public-name pressure below 2.5 MPa. French connections can be divided into five types: welds, welds, welds, pines, screws。Right-angle shaft reducer motorThe screws of the bolts must be complete, they must not be vacant, they must be embedded in nature. The bolts with the same specifications are installed in the same direction. Welding: The internal and external layers of Frank are welded, much used in medium, high-pressure pipes, with a common-name pressure between 0.25 and 2.5 MPa. The principle for the selection of the gasket is to be as close as possible to the small width option, which is the principle to be followed in determining the conditions under which the gasket will not be crushed. The outer side of the tube should be more than 100 mm apart at the location of the French installation on the tube, and the space between the walls should be 200 mm and above. Third, Connecting to Frank: Checks if the specifications of Frank, bolts and gaskets are met. This connection is used mainly for the connection of casting tubes, ducts, non-iron metal tubes and flang valves, and also for the connection of process equipment to flanges. The French-linking process for snail snails is as follows: first, the connection between the French and the pipe meets the requirement that the pipe and the centre of the French be on the same horizontal line. The cover must remain smooth and smooth, and no thorns。Parallel axle reduction powerThere are three types of welded flannel seals, which are smooth, condensed and slurry, which are broadly applied in a smooth and affordable manner. Before flanges are assembled, flanges are cleaned, oil, dust, rust, etc. are removed, and seal lines are removed。

Snail snails are lax: so much is used in less stressful but more edible pipes, so this type of flannel is very edible, and much of the material is based on stainless steel. Welding: A pipe in which much of the use is less than 10.0 MPa and less than 40 mm in diameter. This time, I'd like to give you a look at his motor connectionMotor gearedIt's all installed by Frank, like our four series ofreducing machines, in French, so why is it so widespread? There must be a reason. Let's get up. The centre of the pipe is 90 degrees vertically to the French seal surface. The position of the flannel bolt on the pipe should correspond. For pipelines with rubber plates, the gaskets also select rubber, such as piped pipes. The sealed face of the welding flange connection is condensed and installed in a more complex manner, which makes it more expensive for labour, installation and support materials. The flange of the snail snail decelerator connects two pipes, pipes or equipment, each of which is attached to a flange, and then adds a flannel mat between the two flannels, and then pulls the two flannels together with a bolt to tighten them to a fragrance. The next step is to assemble the French: the French seal of the snail brake is vertically in the middle of the pipe. Do not bury Frank in the ground, which is easily eroded, and if it is necessary to bury him in the ground, it must be protected against corruption. Second, a French gasket, with the following requirements: snail snailsGeared motorwithin the same root pipe, the gaskets selected by the french under the same pressure should be sampled so as to facilitate later exchange. http://boserlgearreducer.com/product/list-wolunwomenjiansuji-cn.html