900w slow-down power unit powered 35. 5t tons of orbital cars. The realization of a small orbital vehicle walker, which follows the orbit under a driver ' s wheel, with a separate set of two wheels from the wheel, allowing the car to travel in a bend, with a smaller side resistance and a smoother running. while the user's orbital car is running, the wheel connects to the electric machine, which is set outside the frame itself, and the wheel is inSlow downScroll down and drive the car along the orbit. In the case of motors, which are inherently retrofitting, if the use of the environment requires a matching brake, the choice is made to use the type of motor brake model. It is possible that some users ' 900w power sets match thereducing machine and then can drive a large load, because the orbital transport process is in a power-saving mode, so he does not need too much output to match to drive the equipment. The left wheel of the wheel, which runs through the left side of the wheel through the perforation of the perforation, is fixed by one hole in the perforation of the perforation of the perforation, and the right side, which passes through the right axis through the perforation of the perforation of the perforation, is connected to the periphery of the perforation of the perforation, with the left side and the right axis being two separate axes, which allow the left side wheel and the right side wheel to travel in a bend, with the left side wheel and the right wheel moving around each side, without interference, to adjust to the curved orbit with the best direction, so that the side resistance is smaller than the side of the periphery, and the small car functions smoother than the peripher. and choose to useDouble- power deceleratorThe matching is due to the operation of such a combination of better controls. How is it appropriate in this case to match a small orbital vehicle walker that contains a frame component set above the trunk of the car, which is placed in orbit。

There are two pairs of perforated perforation, one of which is used to fix the wheel and the other for the fixed wheel. There are also differences between different devices in the selection of models because of different parameters requirements. Further, the wheel drives the small car case in orbit under the gear-reducing engine. one user's request for areducing machine in the previous period was to use 900wSlow down, oneAfter the combination, the orbital car, which drives his load of 35. 5 tons, can this small power power drive the equipment? See some of the details below. The left and right wheels of the wheel are fixed, respectively, by the left and right axes and the strangulations, with the left axis and the right axis being different. Further, the wheel connects the electric power, which is placed outside the frame itself. The scaffolding component consists of the hull itself, the front and the rear, one of which is a gear-reducing machine or a snail-drive-driven driver, and the other - from the wheel, the wheel-driven trunk follows the orbit. There are many transport processes in some warehousing operations that are carried out using various forms of vehicle, as in the case of flat cars with wheels, or or orbital vehicles, etc. if you don't know how to match the power-reducing machine, you can consult b0serlGeared motorThe technologists are required to perform a matching reduction model according to your parameters. In the user selection process, the user requirement is to use areducing unit for matching use, whereas the power choice for the power of the machine is 900 W and the load driven by the power-reducing combination is 35.5 tonnes. Further, the front wheel is the driver, the back wheel is the wheel. http://boserlgearreducer.com/product/list-rxxiilijiansuji-cn.html