S seriesreducing machine ip protection level. the s series ofreducing machines are so good that they can't be separated from our front-line workers, and each process is very tight, and our qc is very dedicated, and we're committed to re-manufacturing the bad stuff with determinationGearbocIt must be through a lot of junctions, and then a part of it will be tested, so you can use ourreducing product. Ip protection, etc. Is made up of two numbers, the first of which refers to the protection of electrical appliances from dust, the prevention of intrusion, etc. (in this case, the externals contain tools, human fingers, etc. , are not allowed access to the electrical holding sector of electrical appliances, in the form of rabbit electrocution), and the second of which refers to the containment of electrical appliances against humidity and water intrusion, and the larger the number indicates protection, etc. Electrotechnical commission) has been drafted to divide electrical appliances according to their dust-proof and wet-gas properties. waterproofing of the s series ofreducing machines can be reached by seven, with very strong waterproofness, as detailed by the s47reducing machine immersed in water for a fixed time or pressure below a fixed scale, which ensures that no damage is caused by water-primation, and so on, which can also be called soakproof, even if it is immersed in water under the prescribed conditionsGeared motorWhat's the protection level? Protection, etc. , is expressed in ip followed by two numbers, which are used to specify protection, etc. the difference is 6 for the representative of protection against the entry of solids; the second digit indicates the extent to which the equipment is waterproof。

The representative of water prevention is eight. protection systems such as the "s" gear-retarder ip (ingress protection) system are supplemented by iec (international)Helical-worm gearmotorIt is also possible to access parts inside electrical appliances by preventing the intrusion of tools of a diameter or thickness greater than 1.0 mm, wires and similar small externals. The boxes of our S-seriesreducing machines are so well-equipped that no tool greater than 1.0 Mm or barbed wire can break into the S47reducing machine and damage the inside parts of thereducing machine. Zero to six, respectively, are the following: unprotected, preventing the intrusion of solid externals with a diameter greater than 50 mm, preventing the intrusion of solids with a diameter greater than 12.5 mm, preventing the intrusion of solids with a diameter greater than 2.5 mm, preventing the intrusion of solid outers with a diameter greater than 1.0 mm, preventing externals with a diameter greater than 1.0 mm and preventing dust and dust. The first digit indicates the extent to which the equipment is resistant to microdust or the extent to which people are protected from hazards in a sealed environment. Our theme this time is S series gearreducing machine IP protection, etc., which is a factor that is often important for the length of mechanical equipment, which has a direct impact on the personal safety of manipulators. Series SMotor gearedO-8 for the second post-IP digital waterproof, which is unprotected, prevents water drops from immersing and 15 degrees tilts, can still prevent water drops from immersion, spray water from immersion, spray water from immersion, flood from immersion, wave from immersion, water from immersion from immersion from inundation. http://boserlgearreducer.com/product/list-sxiliejiansuji-cn.html