The propellers are equipped with 1. 1 kw power for the straw cutter. but in the drive, the drive is often visibleMotor gearedI don't know. With the output of the user, the model can be locked in the range more quickly. Since the user has designed the overall body of the cutter, it will be necessary to make a size adjustment choice in a limited space at this time. The output is 117 turns per minute, the output twister is 90nm, the reduction ratio is 12. 14, the axle direction load is 3210 and the safety factor is 1. 8, the corresponding model being the reduction machine k37 or ka37, kf37, kaf37. So in this case, what are the corresponding models? What factors need to be considered in the selection process? Since the twists required by a straw cutter in the course of its work are not very large, but are relatively fast, it is time to choose a suitable model in the choice of model, which corresponds to actual use needs. Households may select a number of suitable usages for the installation of the equipment. at this point, the user does not have detailed parameters, so we'll tell the user what the parameters can be, and let the user choose one for himGeared motor reducer combination. So it's going to be 117 minutes per minute close to the user's needs, so at this point we chose to use this parameter. The range of output rotations that can be formed at this time is 0.15 to 357 per minute。

The range of matching models can be observed on the parameters of the selected sample, as compared to the k37, k47, k57, k67, k77, k87, k97 and some combinations of the reduction machine models. So there are a lot of parameters in the process of matching a single slow-down machine, so we need to select these parameters for use on a slow-down machine. this is when we're looking at the selection of the k-reducing machineServo motor reducerInformation. This model is the size of a small installation that the user requires to be adequate. But it's not very big for a straw cutter like a user, and we might need to use a smaller cone gear-reducing machine combination on it. Throughout the selection process, what we need to consider is the of the operation and the size of the installation. There were no just 120 turns at this time, but there were close 117 turns per minute and 135 turns per minute。

But the user's need is to use a 1. 1-kw gear-reducing machine to match. A straight-angle gear-reducing machine. In designing the rotor gear-reducing machine used on the straw cutter, it is hoped that the technical staff of the b0serlreducing machine will be able to help him select a suitable motor-reducing machine. today's share of the machines used in the straw cutterSpiral cone gear deceleratorI don't know. This time we're looking at a sample of the K series ofreducing machines from B0SERL. There are also different combinations in which it is difficult to select a suitable model for use without the qualification of parameters, so at this point the user proposes an output rotation of about 120 turns per minute. The deceleration ratio ranges between 3.98 and 9363. During the production of a large number of agricultural equipment, different machines will be identified and operated in different units in order to achieve different functions. So we don't think about using combination-typereducing machines. But the power of the electric power is different because of different machines operating in different ways. http://boserlgearreducer.com/product/list-kxiliejiansuji-cn.html