The crowding out of the ka series of vents matched the up-to-the-morning of the frf to 300 onm per minute. A few years ago, a user of the extruder, he had to choose for his extruder — the equivalent of the electrics and the perforator. So let's figure out how much power the real power should be. let's take a look at the sampleTurn frequency brakes slowing downWhat are the models. Among the parameters required by the user, the current non-existent parameter is the power of the electric power. The power size of the electron from power calculations is 1. 65 kw, using a 5-turn output rate and a 95 per cent transmission efficiency. Selecting such an output rate at this time allows the variable to narrow the range of the adjustment by choosing 3. 5 rotations per minute, with the corresponding output twists reaching 3680 nm, a reduction ratio of 408, an axle direction load of 65000 n, using a safety factor of 2. 2, and a matching contours deviator model of ka107r77 per minute. the title of the moving form is taken into account when a great number of devices select the drive, which is of little use because the mode of connection does not match。

The range of parameters that can be used at this time, if matched by the models above, is also broad, so that the range of deviance ratios that can be formed in such cases is between 3.98 and 6747, while the range of outputs is between 0.21 and 359 and between 4ONM and 5980ONM. 3.9 RPM/min, 1.4 RPM/min, 4.5 RPM/min, 4.7 RPM/min, etc. In order to better protect the frequency transformer of the FM power, we have chosen the medium output, which equals 3.5 per minute. This range of parameters contains the required values of the user, so we can then choose between the parameters. Detailed parameters for BOSERLRight-angle shaft reducer motorThe selected tech clerk sent you. The parameters of the different extruder require different, so there is a difference between the type of the vent-reducing machine selected. Quality user parameters require an output rate of 1 RPM/min, 1.1 RPM/min, 1.2 RPM/min, 1.3 RPM/min, 1.5 RPM/min, 1.7 RPM/min, 2.5 RPM/min, 2.8 RPM/min, 2.7 RPM/min, 3.4 RPM/min.

Ka127r77 concretizer, ka157r97 concretizer, ka167r97 concretizer, ka187r97 concretizer. In such a case, which model would be appropriate for the client? Here you go. use boserlGeared motorThe selected sample looks at which model matches the above parameter requirements. At this point, we can see in the selected sample the matching contours-reducing model of ka37, ka47, ka57, ka67, ka77, ka87, ka97, ka87, ka97, ka97, ka97r57, ka107r77, ka107r77, in the process of equipment-selection, typically the axle-shaped equipment is more numerous, while the axle-generated equipment is matched by the corresponding hole when connecting the power-carrying work. At this point in time, the user determines that it is using a variable frequency generator, so, whatever output is selected, the rate of output of the gear-reducing machine during use will be affected. At this point, the perforation deviator parameters have more than one to five rotations and, in this case, one turns and five turns on the list of parameters. So we can match using 1. 5 kw, and because the user environment is not so bad, we can use 1. 5 kw in such an environment. at this point, his request was madeThrough-hole shaft reducerMatching a variable frequency power up to one-to-five per minute and output of a twist can reach 3,000 NM. http://boserlgearreducer.com/product/list-kaxiiejiansuji-cn.html