How much gear-reducing power is required to boost the load of 3 tons. The wheel can be a roller roller (with a towed tow tort) or a tow tort (with a towed tow tort). Only one parameter is known at this time when the overall load of the user ' s combat promotion machine is 3 tons. Quoted components have a conveyor belt or chain. So in such a case, what kind of slowing motor should we choose? Users need a promotion of 3 tons, and at this point they need to choose an output twister greater than 3 tons for equipment. And the drive consists of the powerMotor gearedThe factory and other transmissions, etc. The strength of the drive required in the operation of the different equipment is different, so the output twist is different in the selection of the corresponding motor-reducing machine, which is then matched by the choice of the corresponding motor-reducing machine, depending on the circumstances. At the time of selection, thereducing machines are of a stand-and-bed type, which is determined to be used for installation using a stand-down or a recoiler, as required by the space and manner of installation. In such a case, the user needs to know the aperture size of the device connected to thereducing machine, and can then determine a detailed value. The output twist thus defines a range, while other parameters need to be determined. With these parameters, it will be possible to determine the type of the slow-down machine that can be detailed. if you don't know how to do it, you can consult the b0serling technician to select the detailsThree-phase variant powerreducing machineModel matches. It is a requirement that the of output of motors be reduced at the gears。

What he needed was a three-ton promotion in a recent home for a combat promotion, at which point should he use a gear-deductive motor to match thereducing machine? What factors should be taken into account when gear-reducing motors are selected? What parameters are needed to select the appropriate type ofreducing machine for matching use? The following is an example of how to use the gears to slow down motors in combat promotions at this time. Different machines require different sizesLow-turn reduction machinethe output axis is from 18 mm to 60 mm in diameter. in general, the main components of the pyrotechnics are the inductive components, the pyrotechnics, the driving units, the lifting units, the roller wheel, the case, etc. he's running for 1 metre a minute. the drive is connected to the wheel, which gives power to and drives the booster. it's the basic operation of a combat promotion machine, and if the whole machine is to work, it needs power support, and at this point we recommend to the users a gear-down motor. there are also requirements during the use of a combat promotion machine, and during the combat transport, it may not be directly connected to the gear-reducing motor, so consider the diameter of the chain-link device at the connecting location, or the size of other diameters, with different diameters. in this case, thereducing machine could be largely established and the main parameters identified by the gear-reducing motor were:Geared motorthe output axle size, stand-on or platter, power of the electric power, and the corresponding rate of reduction (output). and there is one parameter to consider when choosing to use a gear-reducing motor, which is the output axle size of the brake. http://boserlgearreducer.com/product/list-tongzhoujiansuji-cn.html