The lifter matches the rf27, rf37, rf47, rf57, rf67, rf77, rf87, rf97, rf107 and some combinations, if you choose to use the rf97Stand-by gear brakesThe model can be matched to the long equipment for use. At this point, the user requested a standing gear-reducing machine with 1. 5 kw brakes, and then a fleet ofreducing motors equal to 80. Are there consistent parameters that can be chosen when thereducing ratio that can be formed with such a combination of parameters is in the range of 3. 37 to 1438 and the user ' s use requirement is 80? There is no comparable use parameter of 81. 80 or 81. 92 in the sample at this time, which coincides with 80. At mid-april, one user was asked to use areducing machine in a promotion machine, and his request was to use a standing gear-reducing machine to match the power performance of the 1. 5 kw brakes to 80. At this time, would there be a single axle-reducing machine that could be used on his equipment, as required by the parameters? he had clear parameters in the user's method promotion device, so he was choosingInduction Motor 3PhAnd then it's relatively simple to choose the corresponding model. There are many factors to be taken into account in the selection of equipment to select a device suitable for the operation of the assistive equipment. The type ofreducing machine chosen by different parameters is different and the size of the installation is different, so it is important to look at the details and choose which one to use。

If 81. 80 is selected, the correspondingreducing model is rf77, the output rectangular is 810 nm and the output is turned 17; if 81. 92 is selected, the output is 17, the output is 820nm, and the corresponding reduction model is rf87. When used and in the manner in which it is operated, it is more appropriate to use the equipment in such an environment. we chose b0serlGeared motorSelective samples, of the parameters in the sample, are 2ps, 4ps, or 6ps, and in general we assume that we opt for 4ps. The two sets ofreducing machines are relatively close to the user's usage requirements, so the two sets ofreducing machines are then examined separately as to which models are capable of meeting the equipment parameters when used. If you need to use one of your equipment'sreducing machines, and you do not know which one you choose to use, you can choose to consult b0serlreducing technicians to select the type. if the gvs are chosen to match the one-and-a-half-kw brakes, then the gv221500w, gv321500w, gv401500w, gv501500w, and gv501500w are compatible, and thereducing machines that can be formed have a higher rate of reduction, and can range from 3 to 180 at a time when there are just 80 to a timeRight-angle shaft reducer motorThe model is GV401500W180S. At this point, we recommend tworeducing machines for matching use, one for the RF and the other for the GV gear-reducing motor. A combination of the above-selected scenarios is then more recommended for the later gear-reducing machine to match to the equipment length. http://boserlgearreducer.com/product/list-rfxilijiansuji-cn.html