How do you choose a triple 220-vreducing machine for a one-to-sixreducing machine on a roller? Let's look at some details of the user's equipment. This is some of his equipment running. a roller, which includes a rack, a symmetrical top of the frame with a fixed axle bearing, which is supported by the installation of a main axis component between the bearings, a flip frame for the bearing of the plate on the main axle, which is attached to the end of the main axial component with a flip power unit to drive its rolling, and a flip power unitMotor gearedIt is mounted on the power rack, which is fixed on the side wall of the frame through a tilt reinforced plate. It's like an r seriesdown machine and so on. but in the user's description, we don't know how much power we choose and how well the r-seriesreducing model is, because without the parameters of the equipment, a very large combination of the reduced ratio of 56 is known。

During the processing of some of the plates, there are differences in the way in which they are processed, while some of the units may be on the right side of the plate, and when two sides of the process are required, they are to be flipped and then processed. The main axis consists of the central steel tube, which at both ends is fitted with a transmission axis connected to the torque powerer and a supporting axis used to interact with the axial bearings. The end-processing of the axis consists of a keyboard axis, an axial support axis and a pole-to-axis segment, which is connected to the central steel tube. And then, if you start to flip the power, you're going to flip the power, or you're going to flip the gearSnail scalding, which is then driven by a decelerator through a joint axis, which in turn leads to the rolling of the entire flip frame. In the course of its work, it placed the roller in the feeder of the latcher, which was supported by the hard-to-penetrating gear that was delivered through the conveyor belt to the flipping pole of the flipper when the plate was transported to the position of the roller. The racks are welded by ducting materials, fixed to the bottom four corners of the racks, and fixed to the soles of the pads, which are equipped with holes for the installation of bolts to the ground. you can be consulted in detail on the boserl retrenchor selector technical staff, or recommend it

In the user selection process, his request was to useElectricreducing machine - body machineHow would it fit to match the model of the motor-reducing machine that was chosen at the time when the drive-turner was working? Without any other parameter, thereducing ratio of the singlereducing machine cannot be processed, as the combination ofreducing machines with a 56-percent rating is quite large, but not every model user can install or say that it is the best in the sex price. The flip power unit consists of an electric machine, whose output axis is linked to the input axis of the brake, whose output axis is linked to the transmission axis of the main axis through a joint axis, which is fixed at the top of the power frame through a fixed base. So you have to compare, and then you have to choose to determine the model. So there is a machine called the Roller, which is designed for retrofitting, and he needed an electric decelerator to drive his roller in the selection of a user a short time ago, at which point he did not know how much of the type he used to slow down his equipment. And some of the data he's got from the calculations are that because of the need to flipElectric brakeshe needs to use a 56-to-centretard in the run, so how does it fit? here are some details. this was followed by a 180-degree flip of the plate into the lower side line, where the other side was used, thus making significant progress in production efficiency. http://boserlgearreducer.com/product/list-fafxilijiansuji-cn.html