How do you choose a propeller gearreducing machine for 1:59 on a flat machine? During the production of some steel, some steel plates are cut or flattened. The interior of the cavity is equipped with areducing machine, and the motor-reducing machine has a rolling axisGeared motorThe fixed link on the driving scroll axis is a slashed cylindrical gear wheel, with a slashed cytal gear gear on the scroll axis, with a tilted cytrical gear gear on the rods, with a rotor and rotor ' s internal scrolling connection on the cavity, which is connected to the inner wall of the cavity at both ends of the convulsive bearing, which is used to support the scrolling of the rotor axis and to reduce the friction coefficients encountered during the rotor ' s scroll. On the other hand, the upper end of his moving seat is connected by a fixed pole, which is covered by a fixed connection to the pole, the side of the block is in contact with the side of the tectonic plate with a tectonic line, and the fixed connection is limited to the side close to the side with the belt, and the limit plate is located on the upper side of the belt, which has a limited effect on the straight direction of the belt, in conjunction with the mechanism that was previously fixed to the belt, the fixed effect of the progressive belt, the fixed connection to the lower surface of the limit plate, and avoids direct contact with the upper surface of the belt. The user's flattener has multiple substrates on the lower surface of the shelf, with multiple springs attached to the inner wall of each substrate, and a suction at the lower end of each spring. In the selection of a user a few years ago, his request was to useThree-phase variant powerreducing machineUsing his flat, he does not know at this point how large the power andreducing model to match would be more suitable for his equipment to be used, so in such a case, the equipment and thereducing model and functional parameters are to be used on the user's flat。

So we need to know how much twirling the user's device requires, that is, how much power is needed to drive the device, and the reason for the reduction ratio is that it's certain, it's just a choice of different extremes or different typesDouble- power deceleratorThe output varies. However, he was not aware of some of the detailed functional parameters required during the operation of his flats, and therefore was not in a position to temporarily identify the model. And a mechanical device called a flat machine is a series of processing manoeuvres, such as the opening of the steel plate and the flat cut. This is some of the details of the user ' s equipment ' s choice of a hard-to-temperator, but in such a case it is still not known how many electrics and thereducing model would be appropriate to match, so the user is required to determine the parameters before choosing the corresponding model. Then let's look at the details. regardless of which device selects the appropriate electrician and the type ofreducing machine, in which case it is necessary to be aware of the equipment in order to determine the model, the user and the r seriesreducing machine technical staff will communicate further to determine the model, and you can consult with the boserlreducing technical staff or click on the right-hand window to understand the details during thereducing technical staff's communication with the userMotor geareda combination of tita and power to meet some of the detailed requirements of his equipment. http://boserlgearreducer.com/product/list-kxiliejiansuji-cn.html