(c) The condensation of the condensed gear of the flat gears and gear rods. However, in addition to the two reasons mentioned above, the subject of exposure shocks arises in the course of the corrosive corset contact of the standing gear gear。Gear with motorMore impact factors are involved in the condensation of the carptic condensation of the impact, and detailed causes of the impact should be identified through a multifaceted analysis. In the process of the gear-retarder ' s gear-retardation condensation of the shock, there is a need to adequately reduce the vibrating and noise topics in the motion and the use of progressive gear-retarding motors. However, in previous studies, all gear-reducing passive gears impose fixed constraints that encourage shock co-operation in general and more so than when it is not. This paper deals with the impact of gear-reducing gears combined with gear-reducing gear. In this process, the process of exposure to the shock is more complex and the overall effect is more significant when the gear-retarder rodent condensed. In the study of the condensed impact of a standing gear-retarder rodent, mainly using ls-dyna solver calculations, a more accurate relationship between pre- and post-shock velocity and impact co-ordination was obtained. like, whenSpeed-down powerWhen two of the gears are in contact with each other, if the rate of rotation of the active gear is increased, the exposure promotes analysis from the point of view of the kinetics of exposure in the course of the gear. This constraining model tends to overload, leading to the death of passive wheels. The shock process manifests itself in the case of a carving which, due to the transient method, can cause the shock at different relative bases。

The general effect of the impact of the corset ' s exposure has a direct impact on the and effects of the process, as well as on the gear itself, and, through in-depth analysis, when the rate of impact is found to be increasing, the synergy of the shocks is also growing, which is a positive correlation. In the current study, most researchers have noticed two aspects: first, the carving and processing process, which caused the impact of the rodents; and, second, the effect of the shock in the side gap of the gear. In future studies, gearing gearGeared motorOn start-up, the wheel can be seen as a model of round, with a more detailed impact effect between the teeth, which will bring greater impact synergy. For a standing gear-retarder, whether the large gear is still a small gear, the exposure to the shock is certain during the transmission of the rods, and some gear-retarders reduce the subject of the shock by adding lubricant, but the method does not substantially reduce damage to the gears. With regard to the recovery process, the reverse velocity of the active wheel of a standing gear-reducing power plant was reflected in a sustained increase until the initial velocity before the shock, when the combined impact was decreasing and ultimately zero. During the compression of the shock, the active wheel of the gear-retarding motors is retrenching in a decreasing state, but in a growing state of co-operation in the impact. In the course of the operation of a standing gear-reducing power plant, the cog impact is inevitable, and the pivotal point is how to lower the cod impact, reduce damage and improve the efficiency of work。Vertical reducerin the course of their operation, the impact of shocks on shocks is bound to have a significant impact. http://boserlgearreducer.com/product/list-rfxilijiansuji-cn.html