Reduction of s-series gear noise. Snail snails are running, and the noise is a major setback. one of the sources is the noise from gear movementsGear with motorThe noise from the gear in the movement. Improvement of the structure of the rvreducing aircraft: in the design of the s-reducing machine gear case, the closedness of the progressive gear transfer box is a good way to reduce noise, install a deviation device, and add a reduced acoustic pad to the plate of the thin-wall component; to the extent possible, the machine can be installed with the appropriate support or basis, so that the noise can be reduced in such a way that, in cases where there are strict requirements for noise, it is possible to reduce the noise of the snail poles by adding to the surface of the box a layer of resistant material, such as foam, and then to reduce the noise of the snail slabs in the outer packaging. The main points are set out below. accurate control of the side gap of the gear, fair selection of the teeth hardness: no cleavage or small cleavage increases the s seriesGeared motorGear by-peer noise, which, according to the experiment, is within 0.01 mm of the side cleavage of the modulus under the same circumstances and is low. Therefore, a proper increase in the cleavage within a defined range can reduce noise while, on the other hand, the soft side is 1.5-6dB(A) less than the hard side, with the same accuracy as the material。

Improved gear lubrication: the choice of appropriate gear-carriage lubricating and ideal lubricant at the round of the gear can be a good way to reduce s-seriesreducing noises, which are differentServo motor reducerAppropriate lubricants should be selected on a case-by-case basis, and the use of lubricants should not be excessive or too low. The volume of the s series of slowing oil tanks can be calculated at approximately 0. 4-0. 8 l l per kw. For snail poles with an average working temperature above 90°c, pure oil tank lubricants will no longer be used, with the use of wheel-back oil or oil tank lubrication as a wind or other cooling method. Parameters to optimize gears: first, increasing the screwdrivers of snail snails, increasing the vortex, increasing the degree of convergence and reducing the noise, but when the snails increase, processing and installation are difficult to process and install, affecting the actual degree of convergence, and second, increasing the passive tooth width of the s-cycle gears, which causes noise change due to different energy decays, so the greater the cortex ' s decay, the better the lower the noise, the later the accuracy of the progressive s-series reduction gears, if the transfer of the wheel is reduced from 8 to 6, will reduce the coarseness of the gear ' s surface, and the operational accuracy of the progressive gears will have a significant effect on reducing the noise of the snails. changeHelical-worm gearmotorgear materials, coating of the tooth: within the limits of the gear strength, high-obtrusive material cast iron and non-metallic materials are used, to the extent possible, as materials for the processing of gears, or coated non-metallic materials are processed on the teeth, which, because of their good plasticity and resilience, can reduce the radon and wiring impulses during the gear operation and reduce vibrations and impulses and can have a good effect in reducing the noise of the snail snails. http://boserlgearreducer.com/product/list-sxiliejiansuji-cn.html