• recovery of gears and gears for the f series of slowing machines. axes and gears: when processed gears and primary-processed axes are assembled, they are selected for wood-heated, with moderate temperatures and little impact on f series, owing to the high co-benefits of the selection and the difficulty of using pressure and cookingInduction Motor 3Ph electric unitThe strength of the gears, which can be used in the field because of their simplicity, is often used in field tests, when heating is done, with a strong lifting of the gears, with wind-proof measures in the vicinity of the gears in order to prevent the gears from being heated in an uneven manner, slow and slow, and without heavy fire, causing local overheating of the gears, which affects the strength of the gears in the parallel axle, to the extent that the perforation of the gears is swollen to the appropriate size, i. E. , to place the axes in the gears, to mark them before they are fitted, to ensure that they are put back in place, and to stop the fire until the axes and gears are cold and die. welding of axes and gears: in order to increase the combined strength of the axyxy and parallel axyxyxyxyg gears, welding at the end of the gear with a better anti-fissile j427 welding, welding with a small current symmetry at a height sufficient to process the r5 arc, welding with a knock-on to remove internal stress while minimizing f seriesGeared motorThermal transformation of the axis。

The parallel axle-reducing gear axis is operating with an occasional break-axis accident, which, given the magnitude of the impact on both the output twist and the gear axis of the f series of brakes, ensures that the original hardness of the gear and the condensity of the axis are the hubs of repair, and that welding is necessary because of the proximity of the axis to the gear-regation gearGearbocOverheated gears, leading to lower rigidity of the gear surface and difficult to control deformation, such as the use of reaxis and general-key links, and the closeness of the bottom of the key slot to the gear root, which is likely to result in the whole of the gear being broken and the loss of the gear, may also prevent the combination of otherreducing machines with the wheel-resort, and restore the f series of gear-reducing machines by re-axising the length of the line. Welded gear axes, once the temperature has been completely reduced to room temperature, can be processed into the bed and, before doing so, the gear outer diameter shall be used as the basis for the modification of the two real central holes of the axis, with a vortex velocity of less than 0. 05 mm, followed by a needle at both ends of the axis, which shall be processed at the dimensions of the axis, as required by the original drawings, to meet the requirements. Because the retrieving of the back axle and gear will transmit larger twists, the axis of the f-series gear-reducing gear combined with the axle should be determined using a combination of a large excess; the gear-reducing gear must be emptied at the centre of the gear and the gear-regulating gear must be emptied on the bed of the car, and the gear-regulated gear should be tuned to the base of the gear's outer diameter and the end of the car, to ensure that both are not more than 0. 05 mm, so that they can be processed, with a parallel axis of the axle-reducing gear, then drilled in the centre of the gear, and fine-sized to ensure that they are not larger than 0. 05 mmInduction motorThe binding strength of the gears and axes will also be followed by welding work at the combined end of the gears and the axes after the assembly of the axes with their excess strength, which may result in the deformation of the co-axis of the gears of the gears of the gears, so that, at the initial processing axis, there is a greater residual processing of the post-processing process. The material of the original gear axis is 4OCr, which is based on the combination of the axis and the gear, and selects 45 steels that are better integrated and modulated as materials for the new axis. http://boserlgearreducer.com/product/list-fxiliijiansuji-cn.html