(b) The design of a standing gear-reducing machine to be fitted with a fitting. Standing gear-retarding machines are usually fitted with heat or banging methods, damage is caused by electrical seals for gear-retarding, and the other is done manually, which is more labour-intensive and reducedbrakes motor-reducerIn this way, we can save time, reduce labour intensity, improve work efficiency and ensure the quality of gear-reducing electric equipment。

Proximity of a standing gear-reducing device to be fitted with a unit to be fitted with a gear-reducing device at the unend of the gear-reducing device to the axle of the moving axis, with a direct effect of the pressure on the moving axis, with the other end of the unit being pressed through a block to the end of the gear-reducing device, with an average pressure, at the end of the side of the gear-reducing machine, at the average pressure, atMotor gearedThere is a non-damaged pressure on the body; when the thrust bearing is added to the device, the friction between the hand wheel cylinder and the block is removed, the hand wheel is self-propelled and the rolling pressure is more energy-efficient. The gear-reducing power hole is paired with the moving axis, roll-on wheel, rotates the hand wheel with the screw between the wheel and the screw, conveys the gas to the thrust bearing, presses the gear-reducing bearing, conveys to the gear-reducing engine, slowly puts the gear-reducing machine into the wheel through the wheel, and slowly pushes the gear-reducing gear into the drive-axis to complete the gear-reducing engine. The effects of a standing gear-reducing machine being fitted with an incorporated device: after the gear-reducing machine was equipped with some of the installed devices, the number of people who were operated by the original knock-down method was reduced to two, and the time spent on a gear-reducing motor was reduced by 20 minutes from the original three-hour period, resulting in a nine-fold improvement in the efficiency of the work, while the use of the wheeled pole significantly reduced the intensity of labour and avoided the spread of manpower; the average concentration of pressure on the installed device ensured that the gears were concentratedGeared motorQuality of assembly. The wheel cartridges that are loaded into the device allow both to operate at the same time because of the long arm, which saves the manpower of the manipulator and reduces the labour intensity based on the lever method; the load is averaged when the pressure is distributed, the pressure is shifted to the shield by the wheel, and along the axes of the wheel is not easily tilted, making it easier to assemble the gear-reducing machine; and the load is made of a screwdriver between the screws and the wheel, which allows for a simple transformation of the force, and the wheel is coated with a polished oil, both to save strength and to extend the life of the wheel。

In order to reduce the manual consumption of the manipulator and to improve the efficiency of its work, a high gear-reducing machine is specially designed and fitted with a device consisting of a hand wheel, a set, a thrust bearing, a block, a screw and a connector. The gear-reducing device is fitted with a gear-reducing device that is connected to the transmission axis by means of four m16 holes in the bearing axis. rotate the screw between the wheel and the screw, turn the man into the rightStand-by gear brakespressure has reduced labour intensity. this design principle can be applied to other similar configurations of holes and axes, which accelerate work efficiency and make assembly easier. http://boserlgearreducer.com/product/list-rfxilijiansuji-cn.html