A set of rules for the operational safety of the propellers and motors. In the course of transport, when lifting and laying down the equipment, avoid shocks, collisions and severe shock! Crude pumps/pumps are prohibited from supersing each other. The propeller-pattern repulsor set of pumps and electrics and their devices were shipped in a well-equipped manner. In order to complete the relevant work, allServo motor reducerThe security and protection set with the electric power was re-loaded and put in good working condition. When providing a propeller-to-wire set of pumps, no internal preservative treatment was performed on the screw-to-wire set. Unless previously agreed upon by the parties, the propeller gear reduction and electric power packs conform to our general packing guidelines. The lubricating oils, sealing and sealing fluids and valves/parts used are separately packaged and shipped (if needed). Any work on the machine must be carried out while it remains static. Before the re-starting of the rotor gear reduction machine and the electric power set, the protocols listed in the section “First debugging” must be followed. Pumps for the transport of dangerous goods and their installations need to be decontaminated. Pumps and their installations are packaged differently depending on the route and specifications of transport. The relevant statutory statutes must be complied with. YesRight-angle shaft reducer motorIn some cases, the liquid film remaining during the commissioning of the pump on the test table is attached to the surface. If you need to store the pump for a long period of time, we suggest that you agree in the form of a contract to take special in-house anti-corruption measures。

Spiral-convene gear-reducing and electric power set of safety protocols for maintenance, inspection and installation of work: screw-con gearGeared motorThe head of the electrical unit is required to ensure that all relevant functions for the maintenance, inspection and installation are performed by an authorized and qualified staff member who has specifically read and captured the contents of the manual. When the machine is running, it is strictly forbidden to remove the shield of the mobile parts (e.g., axles). It was essential to follow the procedures for decommissioning machines as defined in the manual. Unless the parties have previously agreed to the use of other oils, mineral oils are used in the above-mentioned tests. During the shipment of the whole unit, the rotor gear-retarder set and the electric power set must be attached to the pump and the electric power (rather than to the cyclo bolt of the electric and pump) as illustrated below. The state of the propeller-to-wire pump set and its safekeeping must be checked at least once a year. If the propeller-to-engine set of pumps/pumps is stored in the open, it must be carefully covered and protected from tide or alien. Any spill of dangerous (e.g. explosion, toxic or thermal) liquids (e.g. from the axle seal) must be removed immediately and the rotor gear and electron set must avoid damage to employees or the environment。Spiral cone gear decelerator(b) A safety protocol for the manipulation of staff with electric power: If there is a danger to thermal or cold-state parts of the machine, it must be fitted with appropriate shields at the scene to avoid accidental contact. The hysteria bolts of the electric power plant shall be used only for its own weight and, accordingly, the hysteria bolts of the pump shall be used only for its own weight, and therefore the use of the above-mentioned hysteria bolts for the loading of the electric power plant and the pumps and the additional load they carry is prohibited. There is a need to prevent electrical hazards (see VDE regulations and regulations on local electricity initiatives). http://boserlgearreducer.com/product/list-kxiliejiansuji-cn.html