The R series decelerator model replaces the XLED74-187-22kw brake. So what we need to know is the model he used and the type he wanted to replace. By communicating with the user, you know what the user usedGearbox motorThe model is XLED74-187-22kw, which is a needle-wire-reducing machine. However, the user's rate of deceleration is required, and according to the type provided by the user, the rate of deceleration is 187 at this time, so is there a good rate of deceleration in the corresponding situation? The data show that there is no right rate of deceleration, but there is a closer rate of deceleration of 17237 or 1863, at which point there are three sets of parameters. And some users would say that gear-reducing motors can match. Since both thereducing machine and the user'sreducing machine belong to the same axle, they do not need to occupy much of the space used. This is the related use of the alternative slowing machines that was shared today. We use these two parameters to choose and use them, and in earlier articles, the little editor overbrushed much of the relevance of thereducing machine, but the different customers used to have a lot of problems. So this is the R-type slowing machine. Based on the parameters of the user'sreducing machine, we have chosen the R series gear-reducing machine. In the process of substitution, just the of the output and the twist are enough. He needed a replacement for one of the users just beforeGearbocUsed on equipment, there was a corresponding model. However, the reduction of motors by gear is less likely to work than the r-type. is there room for change in space and in parameters。

On the selected type, we can see rx57, rx67, rx77, r27, r37, r47, r57, r67, r77, r87, r97, r107, r97rf57, r107rf77, r137rf77, r147rf87, r167rf97, all of which match the 22kw. because of substitutionHorizontal reducerIt's not like it's at the beginning. So we have to match the parameters and the installed space to the original power gears. So let's look at the selected type of the r series ofreducing machines in the boserlreducing machine, and take out two parameters of the user's originalreducing machine, one for the 187-reducing ratio and the other for the 22kw power-reducing machine. Depending on the characteristics of the user ' s originalreducing machine and the use of the parameters, we have chosen a hard-to-penetrating machine as close as possible to the installed dimension. The output rate is 17237, the output rate is 55 per minute, the output rate is 3790nm, the corresponding model is r107; the rate is 17237, the output rate is 83 per minute, the output is 2540nm, the corresponding type is r107; the output is 1863, the output is 274nm, the output rate is 76 per minute, the corresponding model is r97. In what case, if there is no right rate-reducing ratio to match it with an output-reverse rate, the same rate-reducing ratio is not required in the course of use because of the three different pace-reverses. However, the output-reverse rate and the output-resort device needs to be matched. but because of the power, the brakes weren't so durable, so he wanted to choose a brake becauseGeared motorit's better and more durable. http://boserlgearreducer.com/product/list-rxiliijiansuji-cn.html