Tests of the F seriesdown machine when it turns: Fifteen minutes later, Seo-suk increased the of the course (100rpm per change) until normal of operation was reached. Check if the F-seriesreducing machines are installed, all bolts are secured, all compositions are securedRight-angle shaft reducer motorIs the spare parts corrected. Thereducing machines in series f, or parts thereof, which are no longer usable or repaired because of a breakdown or the expiry of their lifespan, should be removed and suitable equipment (e. G. Scissors, oxygen cutters, saws, etc. ) should be selected according to the material intended to destroy the machines and their components. Check whether all the protections for the f seriesreducing machines are in the right position. To ensure that the f-seriesreducing machines work smoothly, if the of the work does not match that of the electrics, so as to increase the of the electrics to a large point, to check for anomalies and then to return the machines to the of work and to observe at least an hour. Dangerous areas are those where the safety of employees is at risk when they are exposed to their work. particular attention is drawn to the fact that when the f series slow-down machines are manually adjusted, those who are exposed to the f series do not always operate the equipment in a dangerous area with sufficient light, so that they are not in a position to prevent them completely or immediately, and those who are exposed should themselves avoid, as far as possible, some sudden or latent risk of attack during the operation。GearbocThe purchaser is obliged to have an appropriate and effective signal and alarm system or soundproofing systems and to prohibit the entry of all non-manipulated or expatriate staff or any employee not involved in the manipulation when the machine is operated。

Checks the regularity of the oil levels of lubricating oil in the f-series slowing machines. The head starter is a low-turner starter to check for frictions and manic noises between parts of the f-series decelerator movement. Where there is a source of fire and an explosive hazard, the necessary fire-proofing and measures are used in such an environment. If the of work is reached, it should remain in operation for at least four hours without interruption. For each rate, a test form must be filled in to indicate temperature, noise and observed anomaly. The observation temperature remains unchanged, and if not, the inheritance continues until this is achieved. if we don't stop the f seriesGeared motorTest, should be restarted from scratch. Check that the oil lubrication system pumping station has been activated. Checks whether the bearings are extensive in wear and tear. When machines are destroyed, as far as possible, the removal of their parts (metals, oil, lubricants, plastics, rubber, etc. ) in a different manner depending on their characteristics and to the extent possible, to the professional f-seriesdismantling company. In any event, the f-seriesreducing machines are subject to the local law on the disposal of industrial waste. Equipment may not be used in the following environments and areas: water vapour, smoke, dust, etc. With strong erosion. Where there is a fire or heat exceeding the promised temperature. Check all lubrication points for full lubrication. All parts of thereducing machine in series f must be removed and broken into small blocks so that they cannot be used again. This allows for the completion of debugging certificates. Check that the f-series slowing machine electrical initiative is connected. The operation controls of the f-seriesreducing machines under normal start-up guarantee, prior to the start-up, that the oil and central lubrication systems are normal if all manual points are available. The equipment cannot be exposed to air as it cannot be installed in the open. sureInduction motorthere was no alarm. http://boserlgearreducer.com/product/list-fxiliijiansuji-cn.html