The fixed gear-reducing axis is not balanced and the problem of bending. Similarly, such an instant load shock can result in a mild bend to a severe bend, and when the axis is slightly bent, it can also cause a dent error in many cases, which, when multiple pairs of gear are present, can lead to a confluence of all kinds of modulations, while the energy of their vibrations increases, while the axle of a standing gear brake is more severe, usually accompanied by the impact of the shock on the time-time signal, which lasts more than three points over the same period, and when its impact energy is high, it can cause it to cause it toMotor gearedThe box resonates, and the amplitude is very high, with a pan-box resonance phenomenon. During the mechanical process, whatever parts or more or less of the subject of the process, even the newly manufactured axis is subject to an imbalance, and another reason is that, in long-term use, it has been distorted or bent by a large payload impact, but in many cases it has been caused by fatigue, so the gear-reducing motor is in operation, usually with the failure of the axis when the gear is broken and the bearing is broken. Axle failures include: axle error, axle imbalance, axle bend, etc., which will also seriously affect the overall health of the gear-reducing electric power。

The presence of these axes, which are connected between the axes and the axes in a standing gear reduction machine, gives rise to the subject of the error of the difference, which arises in the design, construction, installation or use of the vehicle, and which is usually the subject of the error of the difference, which is also the subject of the gearGeared motorThe health situation is more productive, with the error of the axis occurring mainly in the position of the axis ' s coaxis, because the error of the axial error causes the axis to be vibrated as a result of the radial alternation in the rotation, and because of the deviation between the axes, the gear transfer process causes a wide-spread-type carving error, which results in the condensation of the gears by the fixed gear-reducing machines。

There is a balance between the axes in a standing gear-reducing machine, and the subject matter of middle and bending follows the progress of the process and the precision of the processing, so long as these imbalances, the median error of the disagreement, and the curve are kept within the given rangeTurn frequency brakes slowing downBoth can be assumed to function normally, although if the imbalance exceeds the established level of the subject, the imbalance will have a greater impact on the health of the opposing gear-reducing machines and may cause the problem of the fixed gear-reducing machines. The balancing topics mentioned here are mainly from the following aspects: the axis-exceed high-impact load can bend and thus cause an imbalance, the axle imbalance can also cause carving errors in the gear-motion process, the condensation frequency of the modulation frequency of the gear-rotation frequency, which is shown on the spectra by a small number of side bands, the gear-reducing motor-reverse frequency component is relatively significant and the vibration energy increases accordingly。Stand-by gear brakesthese forms of failure of the axes cause the loss of gears in a number of cases, as the title of the axis has led to a change in the state of condensation, and both the gears and the axle bearings have been installed on the axis, so it may also be that the working condition of the bearings has changed. http://boserlgearreducer.com/product/list-rfxiliijiansuji-cn.html