A low-turn reduction machine with an electric generator bearing. The weakness of this installation is that the locking of the nut is loose after a period of time between the low-turn reduction and the electric bearingThrough-hole shaft reduceran axle of the bearings with the electrics moved in the direction, and there was a malfunction. the low-turnreducing machine and the electric power set have high locking requirements for the bolted nut when installed on the bearings, and the lock-strength rectangles need to be moderate, otherwise they will result in a lack of staggering of or damage to the bearings, which will affect the service life of the bearings. a set of axle bearings for a low-turner and an electric generator is made of ink or casting steel. low-turn reduction machines and electric power units are more regulated with seamless steel, requiring seamless steel tubes to use small, eccentric tort tubes, and the diameter of low-turn reduction machines and electric power sets is increased by the width of the conveyor belt to 89-200 mm. the transporter system uses a grinding bearing with automatic agitation, and the bearings and axes are installed with an incisive lock and accommodation to facilitate their installation and dismantling. this makes the transmitter less operational and energy-efficient. lithium-based lubrication for axle bearings shall be waterproof and dustproof. double-sealed bearings are used to fill the plant with gills. as shown in figures 2-5-11Servo motor reducerA set of bearings with the electric power gets a good lubrication. The tortator is used to support the material carried by the conveyor belt and the conveyor belt, so that the conveyor belt operates in an uninterrupted manner. State-of-the-art testing of bearings is therefore scheduled (weekly) in order to eliminate the risk of failure in a timely manner. The installation intensity of the bearings is usually based on the expansion of the inner bearings, and the expansion requirements of the different bearings in the inner circle are different and must correspond to the assembly。

When the bearings are assembled, the inverted locks and the inner coil of the bearings will be coated with 220 carb oil to reduce the slide resistance of the bearings on the locks and to prevent low turnsGeared motorCompression with a set of axle bearings and lock-in external surfaces to prevent long-term use of corrosive topics. Refuel the axle bearings with a gas gun for grease lubricating. Axle bearings must meet user requirements (the life of a large transmission system carrier is not less than 50,000 hours). The selected type of the roller bearings are selected by the design loads (still loads calculated on a point-by-point basis) and the roller designs, the rated static load co and the maximum rotation bearing bearing type in the axle bearing selection project, the low-turner reduction and the electric generator set of bearings, and shall be tested for the bearing life of the bearings according to the service life requirement and, in the event of a difference in the lifetime test, the larger bearing type. After the placement of the roller in the field by the installed staff, the axle bearings are fixed by the steel slash. The irradiation consists of steel, plastic, etc. The fixed bolt holes of the shell are designed to make the roller easy to match, and if they are not, they cause the bearing to turn to shock, anothero, reduce the service life of the bearing and extend the bearings to local wear. The axle bearing shell is an open base. stationLow-turn reduction machinethe high number of beams associated with the electrical set of transmitters directly affects the operation of the transmitters in good or bad quality, and their replacement and maintenance has become an important component of the cost of the carrier operation. it is therefore required to be durable, water-resistant, dust-proof, maze-sealed, which must be reliable. http://boserlgearreducer.com/product/list-sfxiliejiansuji-cn.html