Tilt snail snails are used for an overload protection device for the h-type roller. main transmission is throughTurn frequency brakes slowing downAs well as the cross-axis of the 10,000-way axis, which drives the roller stick, the entire conveyor system achieves instant overload protection by a safe and marketed safety axis installed on the snailreducing axis. If the cut-and-twirl rectangles are too large for a rolling power agency to protect safe sales, the load-trucking rectangles that are passed through the roller ' s snails in the event of an instant run-off will greatly exceed the design strength of the roller. The roller rolls in the process of biting the steel, i.e. while the head of the roller bites into the roller, because for some reason the roller's jaw in the rotational state is killed by the roller, which results in a sharp drop in the roller's main conveyor at a high rate of rotation until the roller power plantMicro move motorThe protection and safety sales on the high- axis were cut, and in the course of the instant roller, the actual of the engine's main transmission engine was reduced from 924 to 651 per minute at a short time of 47 ms and from 924 to 651 per minute at that point of time, and was cut at that point of operation, although the rate of brakes on the engine's main conveyor was cut at a rate of 5809 per cent, assuming that it was operating at a rate of 5809 per cent, at which rate the machine would be drawn to zero within one second, it could be assumed that a large load-controlled rotation would be required for the revolving body of the rolling apparatus, which had a high- rotation rate。

On the basis of a full understanding of the damage to the brakes and the cause of the break-up of the brakes, it is necessary to consider, in terms of process and equipment, how to prevent the rollers from going up and down, as well as to effectively protect the rollers from movingGeared motor, restores the cut-off face of a rolling power plant to the original external design for safe sale. In addition, in the event of a sharp increase in the load-rotation rectangular of the rolling power apparatus and in order to contain a steep decline in the of the main transmitter, the main drive-control system of the rolling machine will allow the main transmitter to increase at a rapid pace the electromagnetic rectangular of the main transmitter, so that, in the case of the rolling machine, the load-turning rectangular that is transmitted to the engine's output axis by the rolling machine should be the sum of the dynamic rectangular mass of the main conveyor and the electromagnetic rectangular weight of the main conveyor's output. The main drive of the roller is 0kw, with a nominal rectangular of 15. 5 kn. M, with a maximum turner of kn. M, and a roller stick driven by a snail reduction machine, with approximately the same power structure for each. in the two years following delivery, a steel company, h-type steel, for a variety of reasons, frequent roll-up of 15 rollers across the line, and the occurrence of a roll-on-card accident, not only give a significant impact on production, but also sometimes have a severe impact on the working life of the roller-drivereducing device, in order to move it correctly and reliablySnail scaldingProtection necessitates the analysis of load rectangulars in the form of areducing card. The H-roller power plant consists mainly of the main transmission engine, the snail reduction machine and the cross-axis 10,000-way axis. http://boserlgearreducer.com/product/list-wolunwomenjiansuji-cn.html