The scalding machine of the scalding gear and the motor axis centre are not causing the wet mill to vibrate. Based on the axle bearing vibration phase, the electric and snail snail snail retrenchor flex bearing horizontally vibrates in a direction close to the opposite direction, with a direct vibration in a direction greater than the same direction, and the fault area should be located around the side of the flex-axis, with the characteristics of an angled error. After a while of running, there was a power plant withStand-by gear brakesFlex-axis elastic rubber block abnormalities of aging deformation, which were repaired and put into normal operation, but the equipment spreads vibrations and increases, mainly in electric-driven end bearings and high- end bearings forreducing machines, around 170 micrometres for vibrations, and less than 70 micrometres for a normal-operational bearing. The reprocessing equipment is in good condition, with both end-axis bearings of the electric power being less than 42 μm. An devulcanized wet grinder power unit is connected to theaxis of thereducing machine with a flex-axis, and a snailreducing vehicle with the samereducing axis as a wet grinding machine with a flex-axis, with areducing ratio of 6.3:1 per cent, with electrics working at a rate of 996 per cent and wet mills working at a rate of 158 per cent. The desulphurized humid ball grinder is used for the grinding of limestone in a plastered plaster devulcanization system. Treatment measures and effects: the stoppage inspection found that the central deviation of the F-axis was significant, with the upper and lower mouths exceeding the mark of 0 mm, while the F-axis were swayedGeared motorThe external convection of the side is 0 mm and the external convulsion of the side of the electric generator is 0 mm, as the convulsors are deformed and reassembled. The external convection of the reassembly axis is less than 0.05 mm, while the outer circle, with an open mouth deviation of less than 0.03 mm。

Fault determination: equipment vibration is mainly in electrical-driven bearings andbrakes motor-reducerThe high- end-axis bearings are in good vibrating condition at the start of the operation, indicating that the original devulcanized humid ball grinder is normal. An analysis of the pattern of transmission of vibrations from the point where the vibration should normally be closer to the point of failure than the part of the mass failure, which should be close to the engine and the scalding elastic axis, when combined with the rater and the powerer at both end of the axis bearing the vibration size. The wet grinder consists of the main electric generator, theretarder, the rotor section, the slow-movement section, the lifting unit, the feed pipe, the subpipe, the feed unit, the ring seal, the high-pressure lubrication station and the basic sector. On the basis of the above analysis, it was diagnosed that the motor and snailreducing elastic axis centre was not correct and that inspection and validation were necessary. Following power outages, the drive-end vibrations did not immediately disappear and were significantly reduced, indicating that the vibration failure was not caused by electrical factors and that electrical failure could be eliminated. It works through a three-step machineIt's got a self-lockerconnected to small gears, reduceds directly with large periphery gears, driving rotations in the rotor, with suitable grinding media (spherical balls) inside the cartridge, promoted to a certain height with centrifugal and frictional force, falling in a state of fall, grinding materials entering the inside of the drums through a continuous tube, broken by a moving grinding medium, and discharges the product out of the machine through a spill and continuous gas. http://boserlgearreducer.com/product/list-wolunwomenjiansuji-cn.html