Application of scalding gear snails to a ball grinder. The ball grinderer is connected to the lead wheel for the mine, when the lead wheel for the skin is normally rotated, drives the brake machine, swings the roller track and links the snail poles to the snails' axes, and transfers the rods to the medium- axis, andGearbocWhen moving, the medium- axis moves up and down the moving pole, causing the moving triangular swinging frame to rise or fall, the other end of the tripod to move with the other end of the wheel, and the moving around with its connected lip and tongue, with a concentric claw wheel on the axle of the scalding machine, with five claws on the claws, with the pistons being rotated around the axle, with the steel ball carried from the staggered to the staggered ball, with the steel lip moving up and down to the strenched slide of the ball in the skunk; with the lip being able to send the ball to the line in accordance with the delineation procedure, and preventing a good multi-ball crowding, blocking the ball, with the steel ball standing in line as it moves the strenching line, and with the stubble moving to the stubble of the machine, and the wheeling of the ball to the stubble, with the bar immediately showing the data, while the wheeling. The transmission device is an important component of the ball grinder, working with the two axes of the electric andreducing machines, and the three gear-relays of thereducing machines need to be thickened to prevent rolling-key phenomena when the lever rolls. Establish a lubrication maintenance track, according to scheduleRight-angle shaft reducer motorMaintenance is carried out to stop the use, timely testing, troubleshooting and replacement of lubricating oil when a significant increase in temperature is observed, when the temperature exceeds 80° C, when the quality of the oil is reduced or more copper powder is found in the oil, and when abnormal noise is generated。

We have installed a ball orbit of 60 metres in length and 10,100 slopes, all of which are welded in the squares with angular iron to prevent the ball from de-orbiting, and the electromagnetic gate must be vertical to the ball-rejecting orbit, otherwise the electromagnetic magnet will not soak to burn. When the toller moves up to a higher position, because of the leverage of the bottom, it pulls the ball out of the tip of the top of the towboard, and enters the promotion of the toller through a short anoric trajectory, then when the toller moves down to the lowest point, the toll rises by 11.5 metres to the highest level and, through the lever, removes the ball from the transmission track, with the effect of the electromagnetic gate, into the pool grinder. Iron ore mill ball grinder, still mechanically transmitted, mainly to the slotsSnail scaldingThey are made up of, inter alia, claw wheels, rollers, swing stretchers, tripods, counters, etc. The main motor is activated by a 14-minute turn, driving the snail brake one time, then slowing through the gear, driving the wheel of its three axes with a zero-millimeter curve at the end of the axis in a round-week exercise in the lever that connects, rolling the pole 60 degrees and moving it up and down, moving the poles back up and down at a rate of 0.5 metres per second, rolling the snail at a rate of 60 degrees, rolling the snail at a six-point-six-week length of the snail-reducing wheel, as the transmission rate of the snail is 31.5 times, and generating a one of the wheels with more than five circles and moving the wheel at a round of 0.5 metres per second. Keep an eye on the amount of oil when it comes to gasGeared motorget accurate lubrication. http://boserlgearreducer.com/product/list-wolunwomenjiansuji-cn.html