On the importance of an agglomeration of snail snails. While the run-off has significantly reduced the roughness of the snail snail surface in the gear-reducing box, it has also advanced the accuracy of exposure, with 60 per cent in the gear direction and 65 per cent in the high direction. Such an approach would make up for the deficiencies of traditional run-off, which would result in an average hardness and a significant reduction in the roughness of the run-off. At the same time, it's the faultsSpeed brakes slowing downA good run can also reduce the occurrence of malfunctions and extend the life of the snailreducing machines, as they occur in the early stages of operation. The surfaces of snails, which are often processed, are rougher, and the actual area of contact of snails is small at the beginning of thecutting process, so that the actual load loaded on a unit area is larger and therefore the wear changes are greater. The traditional method of running is grinding and grinding, i.e., adding hard grinding to the ointment, which inevitably produces an uneven distribution of the embedded or run hardness of the hard point, which can easily cause a scratching of the snails of thereducing machine, and abrasive grinding of the grinding material, while the surface hardness is not evenly distributed to produce adhesive damage. Runoff analysis: During the run-off of the servulator, the load, from empty to 120 per cent of the rated load, has a very important impact on the formation of the reactivity film, and it should be noted that the relation between the loading and the timing of the run-off depends on the tooth processing. The process of using cumulation:Stand-by gear brakesAfter cleaning it with shrubs, run-off resin is painted on the top of the snails, then it begins to operate, and the load is increased by one level, each time it is painted on the snails and the coating is not too thick。

Ra = 0.15-0, specular. It is important to shorten the run time only when the snailreducing machine's functional targets are in place. Because of the snailGeared motorDuring the run-off, the effect load between the friction surface and the relative slide has a greater effect on the quality of the run-off, with the friction factor increasing with the increase in the load, in the case of the lower slide, and the friction factor decreasing with the increase in the load when the load reaches a certain value. Also, the price of run-off has been comparable to the price of grinding, and the time of run-off has fallen short, but the quality of run-off has improved considerably. Sufficient for the accuracy of exposure. This is due to the fact that the increase in the payload has no significant effect on the reaction of additives and metal surfaces in the run-off resin when the slide is less rapid; When the of the slide is higher, the increase in the load promotes the reaction of additives and metal surfaces in the run-off resin, and the spread of the reaction film reduces friction between the friction surfaces and therefore the friction coefficient is lower. Upon completion of the run-off, it was found that there was a slight plastic deformation of the snails ' contact top, that there were no significant groove marks at the dental point of contact and at the non-exposure, and that the roughness of the surface of the snails ' face was reduced from Ra = 3.0-3.4 in front of the run-off to Ra = 0.4-0.5, and that the roughness of the snails ' surface was guaranteed from Ra = 1.5-1.7 before the run-off to the run-offServo motor reducerit is an essential and important step towards normal functioning. in the experimental study of steel copper for snail wheel materials, a new run-off method was used to reduce the roughness of the surface of the snail poles in the snail agglomeration machine by chemical polishing, using run-off resins as a precipitating effect. http://boserlgearreducer.com/product/list-wolunwomenjiansuji-cn.html