What do you have to do with brakes for a standing gear-reducing 4kw? You have to take brakes into account in this brake-reducing process, so you have to choose the r series ofreducing gears. And what about the kind of brake that's a standing one? it's simpleThrough-hole shaft reducerThe installation mode allows for the choice of a stand-down or a recoiler. However, not all of the four series of decelerators used for all equipment are so easily selected. Since a stand-by installation is to be selected, i. E. , areducing and electrical device is to be installed on the equipment in the form of a line, at this point we need to choose a gear-reducing r. The data available from the data sorting did not happen to be 600 rpm/min. So the type after screening is grf47-4. 85-yvpej112m. But this is common for b0serl technology staff, who can easily give you the options you need for different use environments. The conclusions drawn as a result of the discussions, as well as the actual measurements, were close to a minute of 600. Since it was determined that the r-seriesreducing machines were equipped with 4kw gear-reducing motor brakes. As the parameters are directly usable, they are nothing to select technical staff. but his original need was for a brake, so if there's a need for an output-reverse accuracy, you can choose to use a frequency brakeMotor geared plus powerIt's going to go with the R-series gear brake. So we can consider the detailed use of the environment as a choice. But there's a closer 598rpm/min. So he had a similar demand, that he had the power he wanted. As in some cases, because of the complexity of the procedures in operation, more complex formulas are often required to produce relevant data。

So which one of the r-seriesreducing machines is in lineGeared motorThe power size. However, there is also a need to provide a deceleration ratio or an output rotation to be fully operational. This was the case for a user in a recent selection process whose equipment required a stand-by installation of a gear-reducing machine, so that it needed to be installed in the process. If there is a relatively high demand for output rotation, then it would be sufficient to choose a variant-modular gear-reducing machine to properly adjust some of the required models. So what we need is a user that can provide us with more parameters to choose. The 4kw gearreducing machine was seen to have a good number ofreducing models, ranging from r57 to r167. He selected a power size of 4kw for the equipment, which means that thereducing machine selects a standingreducing machine for the selected needs. So all these models are available? However, not allreducing machines are adequate, so we need to choose which of the hundreds of these models match. you can choose which one you wantMotor gearedi don't know. do you find that a selection like this is relatively simple after multiple selections? we have different needs to choose between them in the process of choosing the modem. so the whole model is determined after the output is determined. http://boserlgearreducer.com/product/list-rfxilijiansuji-cn.html