How do you choose to match a 2,800-to-one-and-a-half-kw power with a tortator? at the top of the selection process, there's a clear parameter requirement, and the tortator uses a k seriesAn umbrella gear-reducing machine, which is a transmission decelerator in the form of a straight-angle output, whereas the electric power is based on 1. 5 kw, which, when combined, needs to reach 2,800. There were no just 2,800 in the sample, but there was a closer 2755, which was a relatively different range from the other parameters of the closer, in which case the paragraph could be chosen for use. Is there, then, on the sample, a type that meets the requirements for use that can be used by a shredder that is adequate to the user? at boserlGeared motorThe selected type ofreducing device on the selected sample is a k37 transmission-retarder, k47 transmission-retarder, k57 transmission-retarder, k67 transmission-retarder, k77 transmission-retarder, k87 transmission-retarder, k97 transmission-retarder, k87r57, k97r57, k107r77 transmission-retard, k127r77 transmission-retard, k127r87 transmission-retarder, k157r97

In the case of different equipment, different devices are selected for matching because of different use requirements, but in many cases, or because of the work environment, the equipment needs to be re-selected for use. How is it appropriate to choose the type of moving device in this selection process? At the beginning of the month, a tortator user was encountered, and his request was to use a k-series drive-reducing device to match the 1. 5 kw to 2,800. In such a case, it would be more appropriate to choose which model to use. Below is the selected type of boserlreducing device to see which of the samples is required to meet the user’s parameters. The deceleration ratio is fixed for the parameters of the braker, and there will be no significant change, so the deceleration ratio will not be regulated but the can be adjusted, so the normal method is to adjust the rate. if during the selection you do not know how to select the retarder, then you can give him as many parameters as possible for the technical staff of the boserl to select the type。

It's based on the user's requestElectricreducing machine - body machineThe matching model and corresponding parameters. In the case of the choice of a tele-driver, this may be the case with the client above, where the parameters of the equipment are not matched by those in the sample of the tele-driver, and how should they be addressed? At this point, a matchingreducing device can be used by a party to make a corresponding adjustment, as if the type of generator was converted to a variable-frequency-modular power, at which point the adjustments could be made in accordance with the requirements used. K167r97 retarder, k187r97 retarder. The corresponding output rotation rate is 0. 52 per minute, the output twister is 24200 nm and the axle direction payload is 150,000, with a safety factor of 1. 3. So let's take a closer look at some of the parameters on the sample. The models listed above are those that match the use of 1. 5 kw power and that form a wide range of parameters for users to choose in combination. At this point, the range of deviance ratios that can be formed is in the range of 3. 98 to 6747, the range of output rotations is 0. 21 to 359 per minute, and the range of output twists is in the range of 4onm to 59,800nm. At this point, the type of the corresponding transmission decelerator may choose k167rf97 or kh167rf97. now we need to find a sampleMotor-gear reducerparameters with a reduction ratio of 2800 are used. http://boserlgearreducer.com/product/list-kxiliejiansuji-cn.html