The locking structure of the hanger's output end. Snail snailGearbox motorIt's a power transmission. It's traditionalStand-by gear brakesThe mode of connection between the output end and the moving component is mainly by means of an excess connection or manual installation; the installation is too cumbersome and the installation is so stringent as to require a public deviation on the output axis that, if the diameter is too large, it will not be installed and if the diameter is too small, it will not bite after installation. In practice, in order to increase the lock strength of the equipment, it is possible to process a cone at the end of the output axle, and to process a lock axle that matches that end, with a cone in the inner hole of the lock axle, to insert the output axle into the snail, at the time of installation, and to load the lock axle into the end of the lock axle, with a small button to reset the end, and to make sure that it is solid and that it is reinforced with a gasket and that it is chained with a screw. Once installed, ifGearbox motorDismantling is difficult, if not difficult, when a general failure requires maintenance. This oneGearbox motorThe output end locks on the structural strength of a simple structure, the installation of dismantling, the increase in the life of the equipment, the improvement of the efficiency of the work and the reduction of the business capital. It's a simple structure. It's very simpleGearbox motor, the end of the output axis will be removed with a small button, as this axis is installed in conjunction with a hole cone, with a seamless connection, an increase in locking, a simplification of the manipulative steps, and a reduction in the size of theGearbox motorThe degree of wear and tear increases the lifetime of the equipment。

Detailed means of implementation: When installed, the locks can be inserted directly into the axisGeared motorIn the snail, and then lock the end of the output axis through screws and gasketsGearbox motorThe case is installed quickly and increases the locks between the locks and the snails, while reducing the wear and tear, and only the end of the locks can be removed when they are removed. A new kind of snail snail can be used to solve this setbackGearbox motorThe output end locks the institutions, including the snails and the output axes consisting of the load-connected end and the lock-string axis, with keys on the said lock-string axisGearbox motorThe inner hole of the end of the snail wheel has a cone, and the end of the output axis has a cone with it. The working method is to process a snail snail at the output axisGearbox motorThe cones of the inner hole of the medium snail, which, when installed, can be inserted directly into the output axisGearbox motorIn the snail, and lock it tight. Or if you can't get the locks, the output axle and the snailGearbox motorThe existence of a small gap will lead to increased wear and tear of the equipment and a reduction in its wear and tearGearbox motorLife expectancy and quality of work. DismantlingServo motor reducerin which case the screws can be removed for replacement or cleaning only if the screws are released and a small button is struck at the end of the output. http://boserlgearreducer.com/product/list-safxiiejiansuji-cn.html