The hyperbolic decelerator on the automatic cutter was combined with an 11kw decelerator to form 200-by-cent. This is how a hyperbolic hard-pattern brake matches the electrics in the selection and matching. So there are parameters for use that are adequate. in a recent selection, one client asked to use a 75-type tkmSlow downSo, the matching power is 11kw, and the requireddown ratio is 200. Will this be enough? Let's look at the detailed selection process. The output of the 2p is 2,800 turns, and the twisting is relatively small. During the tkm hyperbolic decelerator matching the 11kw motor, the range of the deceleration ratio varied between 75 and 24429 through a selected sample of the boserl decelerator. What's going on? It's two values that are tested in an experimental environment and that are of reference value in an experimental environment, but it's different from what's actually being used, which may be a legend error. This is the set of parameters chosen today for thereducing machine and the model of the electric machine, which are selected in accordance with the user ' s requirements, at a time when it matches the power unit of 11kw of 2p, at an output rate of 136 per minute after thereducing machine, at an output rate of 712nm, known as 200, actual 20629, with an axle-direction load of 7870n, using a safety factor of 11, which corresponds to the two types of thereducing machine tkm68c80b5 or thereducing machine tkb68c80b5, both of which are 2p. This is the type that the user requests to select. Because of the different output twirls of different electric units, the reduction is different. a lot of clients are choosingGeared motorIt's not clear what type is appropriate at the time, so it's a little confused about the type selection, how to look at the sample of theing machine, and too many parameters cause interference in the selection process。

If you do not know how to slow down, but the equipment needs to use it, you can contact our technologists, who will choose a suitable electric tracker to use it on your machine. along with the improvement in the frequency of use of the servers used, an increasing number of users use tkmRight-angle shaft reducer motorMatches the server. So how should the tkm hyperbolic-driver look at what in the selection match? How should it be? If the type and shape of the nmrv snails are chosen, then a single decelerator does not meet the requirements for use. But we still recommend that users use this set of parameters for matching, since the parameters for this set of hard-toe brakes are closer to the demand for use, and the others are far apart from being suitable for small-scale equipment on mechanical equipment, and there are often some equipment or devices that require small power structures to enable the equipment to function properly. But using a tkmreducing machine, we can use a one-by-onereducing machine to meet the need for areducing ratio of 200. In the course of the operation, some of the equipment requires only one small electric power to be sufficient to operate the equipment, while some of the slightly larger reduction machines are used on the equipment. Let's see how the parameters can be. trueGeared motorthe selection is always made around the parameters of the device. a 200-to-200 ratio can be seen from the parameters of the data, but the actual deceleration ratio is known as 20629 in the experiment. http://boserlgearreducer.com/product/list-zhiajiansuji-cn.html