Installation and removal maintenance of a set of r-reducing electric appliances. If one of the r seriesreducing machines is equipped with a mid-air axis with a copper suit, the grease can be lubricated at the surface of the solid axis in contact with the copper set. The bolts can be tightened only when the mid-air axis is fitted to the solid axis. Suppose.Motor gearedWorking under harsh conditions (e.g. high air humidity, erosion media and large temperature variations) requires shorter replacement cycles for lubricants. A slight tightening of the bolt to fix the position of the outer French plate. The replacement of lubricant should be accompanied by a thorough cleaning of the R series ofreducing units. A set of a condensed disk of installed R-seriesreducing machines does not need to be maintained. The axle of thereducing machine is removed from the solid axis. If synthetic oil is used, the replacement cycle for lubricating oil can be multiplied. The area of exposure with a set of screws and bolts from the multi-purpose oil grease re-prime R series. Do not put grease on the surface of the solid axis under the disk. The middle axle with a condensed accelerator, disassembly, and look at the components of the R-seriesreducing engine set of axes: only at re-installation (e.g. after long use) will it be necessary to break up and clean up thoroughly. Re-prime the cone of the outer French plate and inner ring with molybdenum disulfide lubricant above G-Rapid or lubricant of appropriate quality. Medium AxisGeared motor) deleting of the grease-locked bolt din931(933) - 10. 9 per cent solid-axis and mid-space-axis hole-to-penetrated user-column-column plate。

A set of rectangles for the r-reducing motor set, the parts and the bolts. Using a set of r-seriesreducing machines with the same twister and a clockwise or counter-clockwise direction, all bolts (a thousand can't match the corner to the bolt), the r-seriesreducing machine set can only roll about a quarter to a half lap at a time. maintenance: loose in minutes by clockwise or counterclockwiseZip gear reductionA set of bolts per lock, which can only roll about a quarter of the time. A small oil lubrication of the inner hole of the concussion so that the concussion can be installed lightly on the medium-altitude axis of the brake. Danger: the bolts cannot be completely removed. Dismantling: the inner circle disks split between two are ready for installation and need not be removed before installation. Combination of the abbreviated disks to the mid-air axis and installation of a set of mid-air axes for the r series of reduction machines to the solid axis. Whether or not the refuelling set for the r series ofreducing machines is a waste of oil, synthetic oils and mineral oils are not allowed to mix! The r seriesreducing machine set will have to be replaced with lubricant oils after 10,000 hours or more of work. Check the oil table as scheduled. Until the tight twist reaches the specified twist value (see table). The combination of a set of mid-altitude and solid axes of the r seriesreducing machines must be cleaned and removed from the surface without any grease. you'll be able to roll the inner ring easily, then you'll be able to remove the gap between the outer french plate and the inner ring with a little hand-strength of the r series。Hangerreducing powerset of installation instructions: dismantling the transport compartment between two outer french plates (if available by the manufacturer). http://boserlgearreducer.com/product/list-rxiliijiansuji-cn.html