Pre-preparation for the installation of a brake to slow down the electrical set. Checks if all the components of the machine are on the same side of the support, and there is no difference in the level of the adjacent parts, and adjustments are made using instruments. Five centimeters of dirt, if it's possible. Run for a few weeks and recheck the strength of the foot bolt. Installation, sub-operation and testing should be done by professional or specially trained staff. H+0.5mm. The base of all machines is on the ground. In particular, it is important to ensure that metal structures and electrical initiatives are well located. InspectionParallel axle reduction powera set of electrical installations, including transmission lines, lead lines, distribution boards, current reverse current breakers used to intercept short circuits, power sources, cable lengths, ground systems, etc. the set of public transports for brakes is: be aware that the above manoeuvres, if greater than 2.5 m of high-altitude work, must be performed by trained staff and equipped with appropriate personal protections, appropriate tools (automated handling vehicles, scaffolds), taking into account the following factors: type of working space, environmental characteristics, ground features, height and availability of the brake set of work space, weight and size of various installed components, etc. press the following table to twist the data to tighten the fixed bolts, and adjust all horizontal and direct surfaces and then water the bottom seat after the brakes have been tightened and a set of foot bolts of the brakes have been reduced. in particular, it is necessary to ensure that the ground is suitable, secure and that the level of error is such as to establish site safety protocols in accordance with local law. install appropriate signal systems to dynamically show the installation process。Double-hole output reductionInstallation of a set of spare parts: the necessary construction work is planned。

In order to be able to install a set of brakes, the users will have to do some preparatory work, in order, to check the brakesGeared motorIs a bottom set appropriate? Whether the base or the ground is still ground, it should be as long as it relates to the static and dynamic reflection of the equipment. The bottoms of the various machine beds are correctly checked for size on the roller axis, and are shown by piano wire, which is defined on the ground map. Therefore, this section contains general information on staff who coordinate construction sites. Identification of disposal, storage, location of installation, with appropriate fences and removable barriers. The size of the condensed surface can be seen from the base map provided. Check the suitability of the machine ' s manoeuvring space, passages, walkways (for escape). The installation of a set of brakes should be able to meet accident prevention requirements, safety requirements for energy systems and safety requirements for one set of brakes and all working equipment. Metal pads that are as close as possible to the foot bolt are required to ensure the correct positioning. With regard to the configuration of a set of parts of areducing motor, strict compliance with the instructions requires, inter alia, that it is established that the installation manual for areducing motor is indeed the characteristics and use of the machines installed by this machine, and that it is a reality that the machine's load capacity is greater than it is. With a piano line and an optical horizontal instrument, the roller axis is carefully located. All gear brakes slowing down should be based on a well-established foundation to ensure that the whole machine is non-disturbed, at a level of long-term resistance to possible shocks, even when it operates under stress. Check transportSpeed brakes slowing downthe functionality of a power distribution system and any other energy support systems such as oil, water, gas, heat, etc. http://boserlgearreducer.com/product/list-ffxiiejiansuji-cn.html