Method of repair after the failure of the gear in a standing gear-retarder. When the gear of a steel gear is broken, the metal can be melted into the damaged surface by electric welding and then refired into the right tooth. This method of repair could also be used to repair large snails. The pressure angle of the gear must be the same when you change it, or it will accelerateHangerreducing power(b) Repairs for broken gears: When the gears in the flat gears are broken, they can be fixed by bolts and plywoods, or by approaching the cut holes on both sides of the wheel and filling them with nails, together with two poreds, which are smaller than the stairwell space, then heat up to 250-300 degrees C, then tighten the cortex after cooling and strengthen the break. Method of repairing the broken gear in a standing gear-reducing motor: Welding gear method. When the gear of the steel thermally treated gear is broken, it may be repaired by the dentation method, by which the next gear of the gear of the broken gear is covered with greasy teeth (5 per cent fire-resistant, 45 per cent fine asbestos, 5 per cent water glass), then the breakout is receded, the glitter is removed from the fire, the teeth are cut off with a stubbed or tubbed, and the tails are processed, and the pre-fabricated greasy teeth are fed into the tails of the stench, and they are fixed or welded with bolts. To alleviateRight-angle shaft reducer motorGear repair in motors can be done using a copper curve model for welding; and glyph repair. It is then covered with greasy grubs, which are recoiled, and the gears of the gear-reducing electrics can be sharpened;

When the gear-reducing power is run by a fixed time, it causes wear and tear, wear and tear of the gear, and the tooth is coated with metal, and the edges and noise increase. It's in a standing gearGeared motorIn the case of small gears and big gear rods in operation, the small gears of gear-reducing machines are often worn quickly, and they need to be replaced in a timely manner in order to avoid accelerating the wear of big gears. Welding may also be carried out at the foot of the slope at the break-off and the cracks may be tightened, and when the gap reaches a small or eliminated level, but the welding may be prevented and the teeth and the dentures may be protected from deformation. For some of the more complex gears (e.g., bouquets) in the interior, which are difficult to process, a replacement wheel method is usually used to repair after the gear-reducing engine has broken. The repair process is to remove the wheel of the standing gear-reducing machine and then press the pre-fabricated wheel overload and fix it by welding or bolting and then cut the gear. An adjustment shall be made for an increase in the side gap caused by wear and tear on the gear or adjustment mattress after the fixed time of use of the gear-reducing motor, in which the two gears of the standing gear-reducing motor move along the axis, so as to reduce the side gap, and, when adjusted, select the thickness of the coating to fix the gear position. The gear is down, and when it's severeVertical reducerthe gears would even be broken, in which case a new gear would be replaced and the money would be higher. in order to reduce the cost of replacing the routing method, the mini-coding summarises the repair of gears in several of the vertical gear-reducing machines. http://boserlgearreducer.com/product/list-rfxilijiansuji-cn.html