The importance of r-seriesreducing-axis to medium. Accelerators are installed to retain sufficient venting space for fans, and if not, switch to other cooling methods. In order to protect the axle seals, the heating coaxies should be controlled in order to prevent overheating and to avoid the use of heat shields to reduce thermal radiation in an environment above 100°c, otherwise affecting the useful life of the seals. promiseGeared motorThis is a shock to the low level of motor, original power and drive. The importance of joint axes to the medium: the adverse effects on the contact and co-ordination of the components that interact within the tilt gear reduction machine are extremely bad, thus reducing the service life of the r series reduction machines, and can result in the excessive temperature of the r series, oil spills and high energy losses. When a driver is installed, the correct pairing of the components is ensured. A good middle pair can reduce the axle bearing direction and radial receptivity of the tilt gears, extend the service life of the bearings, make the movement better non-controversial, reduce wear and tear of the components of the cascades, and ensure the non-controversial alignment of the gear rods in a dynamic operating environment. the central line of the transaxis must be the same when the machine worksBig load retarderIf preheating is required at the time of the installation of the coaxies, it is recommended to use either oil bathing or heating furnaces to prevent deformation on average. Between the interconnected axes, if an angle error and an axle error beyond the promise range occurs, increases the load of the coaxies and leads to premature wear and tear of the parts, as compared to damage to the axles and bearings of the gearing gears。

The basis for contact with the foot of the agglomeration gear should be accurate and at the same level. If possible, the margin should be zero. When installing the axis, the gear, bearings and locking rings should be damaged by the installation of a suitable installation tool, which should be carried out in such a way as to prohibit external force tapping。Helical-worm gearmotorThe precision of the coaxies is a very important factor in determining the service life of the axes, bearings, seals and coaxies. In any case, during the error of the coaxis, no more than in the error of the large margin of disagreement, the details can be found in a copy of the connecting axis. For the medium pair (vertical direction) of the drive parts, it is proposed to add a gasket below the installed foot. All of these factors confirm the importance of the axis for the use of the slasher. Horizontal adjustments of the drive are also made using screwdrivers on the ground. the neutrality of the differences between the r gear-reducing motor axes may be caused by assembly, or by actual manipulation, such as thermal expansion, lack of rigidity on the shelf, if based on a welding structure, should be sufficiently rigid, and an insufficient base or frame component would lead to an error in the direction and axis of the operation, which cannot be measured when the tilt gear-reducing device is static, but which would have serious consequences in the operationHorizontal reducerbroken axes, oil spills, damage to bearings, etc. http://boserlgearreducer.com/product/list-rxiliijiansuji-cn.html