The r-seriesreducing machine is tired. the term fatigue should be more visible to all, and as it is more professional and more common, today i want to give you an idea of what it means and how to deal with and prevent the occurrence of r-series slowing machines。Spiral cone gear deceleratorThe simple phrase of fatigue is that, in the absence of maintenance or a poor working environment, there is a common error, and it is important not to worry about it, but it cannot be ignored that the novels are often overloaded with even small items, and that each small detail is likely to destroy the r67reducing machine. So remember, the little one is likely to cause the retorts to wear. Of course, there is also a way to prevent the retrenchment of r-series tilt-wheel-reducing machines, that is, 200 to 300 hours after r-seriesreducing machines are in operation, the first oil exchange should be carried out, and the quality of oil should be checked periodically for subsequent use, and the oil must be replaced in a timely manner for incompetrating or deforming. in general, r97 is permanently disabled for refuelling machines that work continuously for a long period of 5,000 hours or every yearGeared motorNew oils should also be replaced before they can be restarted. Be aware that the power supply of the transmission power system is to be blocked to prevent the accidental transmission of electricity, and that, in the course of work, when temperature rises above 80°C or in the tank above 100°C and abnormal noises are observed, the use should be discontinued, and the reasons for this need to be removed and the lubricant replaced before it is allowed to function。

The r-seriesreducing machines are subject to a rotational, convective pressure, with surface metal materials extending from plastic deformations to tiny cracks to cracks to surface metals falling off (point erosion), which, after long-term operation, produces a slight erosion. the dotage caused by poor material heat processing is often smooth, and the dotage caused by uneven heat treatment tends to be concentrated at a certain point in the gear。Gear-retarding machineToo large axle bearing vibrations lead to an increase in payloads, as the gap between the bearing and the bearing hole is too large and the length of the conveyor bearings is strong, leading to an axle vibrations, resulting in an increase in gear transfer loads, and to a dentary erosion. At this point, the r-series brakes can be used to replace the more intense transmission axes and to repair the faults in the bearings or reduce the rate of promotion to extend the service life of the gears. Thereducing machine shall be added to the same oil as the original number and shall not be mixed with the oil of the different number, which is the same and has a different viscosity; the oil shall be replaced until the r107 slow-reducing machine cools down and does not pose a fire risk, but it shall remain thermal, as the viscosity of the oil increases with the complete cooling, so as to make the oil difficult. For example, when the gear works for a long period of time, it is in the form of a caricature erosion of the r series of reduction machines. This can reduce the load. This will require the replacement of gears. unauthorized advances in the use of loads, resulting in fatigue on the teeth。Motor gearedthe choice of lubricant is unfair because the use of lubricant is too low or ineffective, there is no oil membrane in shape between the teeth, and the direct contact between the teeth causes erosion, and the need to replace the fair lubricant or progressive viscos improves the state of the dotage quickly. http://boserlgearreducer.com/product/list-rxiliijiansuji-cn.html