the two-polar reduction machine and the electric power plant were painted. owing to the strong permeability of epoxy permeability, there is a better investment than in phosphate varnish. the surface is treated with a phosphate base paint of 6-10um, followed by a paint package for the entire product, but not as a follow-up paint, with a direct mid-level paint being feasible, depending on the total paint thickness requirements. at present, new solvent-free epoxy paints are being introduced to replace phosphate-based paints. bipolarGeared motorAll surface paint repair works should be completed prior to the electrical set of construction, and the entire coastal bridge should be completed at the same time in a relatively short time to avoid colour differences. Intermediate paints (epoxy) promise to use rollers and paints as an aid. Sector paints can be painted in front of the users of the bridge delivery. The epoxy mid-varnish solidification time was also around 7 days, with a dry surface of 4-24h and a construction temperature of between 5-350C. Therefore, sandpaper should be used to grind the surface and be accompanied by clean water. The mid-painted membrane is thick, and diode-reducing machines and electric generators are to be constructed using diluents in a fair manner to avoid drifting. In practice, however, the construction of midway paints of snail snails with slashing gear tends to take a long time, when, in addition to dust and oil contamination, the surfaces of the base paints also have zinc powder oxides — zinc salt — whose presence severely affects the investment between the paints, resulting in the failure of the paints。GearbocPort equipment coatings should be carried out by a combination of roll-on and spray-painting, and should, to the extent possible, be used to achieve good surface effects, in addition to the inaccessible high-altitude or small, inoperable areas。

Theoretically, the bottom paints are solidified, removing the dust and oil from their surfaces, so that the rear-track process of painting can be performed. Servo motor reducer snails with slashers and stainless steel parts are painted with a solvent that completely removes oil, grease, moisture from the fabric ' s surface and uses sandpaper or power tools to graze the structure ' s surface, so that it has a defined roughness and paints it in a dry environment. Potamine latin is extremely sensitive to the moisture, so make sureServo motor reducerClears the surface moisture of the components and works under 85 per cent of relative humidity. The paint works were carried out in high conditions, cleaning the surface of the front of the front, cleaning up dust, moisture and oil, and grinding it with sandpaper, so that the surface had a certain roughness. The two-polarreducing machine and the electric power plant were to be painted in a very face-to-face manner, with the average of the paint membrane and the full coating of the paint, to avoid leakage and defacement. The surface should be luminous and smooth, and the construction temperature should be controlled at 5-350c. It is important to clean the surface work and the construction environment as a rear paint of the building blocks. a set of power sources for the binoculars and the electrics is provided by the 6kv matrix of the transformer, by cable to the ground trunk, by cable rolls and on-board assembly of slides, and then by the pilot entering the lineboard, in two directions: the road directly supplies the snails of the sloughs of the sloughs of the slanted gear with the gravitational graft, the other way to the power transformer, the control method is to use a frequency-modified modulation, with a communication resistance on the side side of the feeder, which is used for the high-momentation back-to-wire feeder network in the process of the transformer, and the long-ranged, which is a smooth and non-impact-free startDouble-polar slowing machinewith a set of parameters that enable failure detection, failure recording, failure removal guidance, supervision and adjustment of the working frequency, current of work of the electric power, mechanical protection, such as over-force rectangular protection, and the prevention of electrical failure during the operation of large machines, etc. http://boserlgearreducer.com/product/list-saxiliejiansuji-cn.html