Pre-operational check of the lowerreducing and electric sets. Whether the slow-down machine is in a normal state with the electrical set of pick-up machines, the welding and connection is loose, the skin is intact, and the steel line slider is available. Fighting wheels are strictly prohibited from being loaded with a load of material; taking up material shall select the appropriate intake amount according to the weight of the material, and overloading shall be strictly prohibited, and when taking down material, the fighting wheel shall be prevented from touching the ground. Unlock the anchor. Put your belt downGeared motorSpecial attention should be paid to the operating condition of the tort wheel and to the timely handling of card obstructions. The Inspectorate carries out the Inspection in strict compliance with the Safety Inspection Protocol for Large Mechanical Staff. Instruments, instrumentation, limit switches, detection of protective devices, communication equipment. Operators are placed in zero. In the event of heavy rain, mist, bad sky colour, which results in a loss of sight or wind strength of up to seven, work should be suspended; wind anchors should be immediately used when wind is above seven or when a typhoon alert is received. The lubrication at the lubrication points is in good condition, and the gear snail snail is in good working condition. Lights are good. In case of an emergency shutdown of a snail snail slug, the cause must be identified and the failure resolved and the work resumed. Check the technical state of mechanical and electrical equipment: electrical equipment and cables are intact。GearbocWatching changes in observation meters and signals during the operation of the pick-up machines, finding that anomalies should be processed in a timely manner, closely observing the sound of the wheel ' s work department, the temperature changes of the bearings and the vibrations of the connecting department, immediately suspending the subject matter. The low--reducing and electrical sets of equipment must be operational at a low rate, with no high- start-up allowed, and the rate of change should be smooth, with a “zero” back-to-back shift。

Examination of the work environment: whether the wind chain has been unconnected, whether the cylinder has been plugged and whether the barrier is suitable. Special attention should be paid to the automatic operation of the snail-reducing machine for scalding gears in order to prevent the accidental movement of the electrodes. Before the low--reducing machine is connected to the main circuit of the electric generator's material set, it is necessary to confirm that the high-voltage power voltage is within ±5 per cent of the normal value and that the excess should be restored to the transformer in a timely manner。Servo motor reducerBefore thinking about the material, contact the central control room and the control room instructions are strictly enforced. The main power supply, the main power supply gate, the opening of the key switch, the sending of the control power, the warning of the alarm, the sending of a moving signal, the working methods of the slowdown machine and one of the electric chargers, the twirling of the “manual” position, the subsequent activation of the walker, the armband or the lifter, in accordance with the requirements of the work, and the strict manipulation of the control room's commands and procedures, and the strict prohibition of the violation of the rules and regulations, so as to ensure that: man-manage, person-supervised, and machine operations are carried out without the possibility of leaving his post. In operation, it is strictly prohibited to touch the rolling parts, to perform cleaning, maintenance, etc. of the rolling parts in the operation, and to move or pull the belt or material on the equipment. Accessibility is available within the scope of the work, and the eyes and ears are evacuated. Short relays, contact devices are not allowed to be used for head starters, and hand-plugs are prohibited to control the stoppage. It is strictly forbidden to enter the high-pressure electrical room and the low-pressure electrical room, and it is forbidden to open the high-pressure cabinet except for maintenance, and it is prohibited for non-staff personnel to board. In the event of a mechanical mover's position or a general meeting, the person in charge shall have exclusive supervisionSlow downthrough the cable. http://boserlgearreducer.com/product/list-sfxiliejiansuji-cn.html