Bans on the operation ofreducing machines in series f. Note that condensed air manoeuvres of the f-series decelerators must be performed with protective glasses. Professional manipulation of run-off f-series or certain parts of the system (e. G. , checking the performance of f-seriesreducing motors, adjustments to the electrometer) would put staff members in a very dangerous situation and would therefore have to strictly observe the following designations: the need for manipulation procedures against the manipulator, the possible risks and how to accurately avoid them, etc. , and the authorization of the company。Motor-gear reducerPrior to the commencement of work, and where possible, the staff responsible for maintaining, inspecting, repairing, should block the power supply and take the necessary precautions to ensure their safety. In particular, the following elements require careful attention before work is undertaken: if, in exceptional circumstances, a staff member of the f series ofreducing machines is required to destroy or to open or remove protection barriers to perform special technical maintenance work, inspection or repair work, the block should be repaired immediately after completion of the work and no alien, mechanical tools, etc. , should remain in the machine, which could cause damage or malfunction. The following manoeuvres were carried out prior to the start-up of the f-seriesreducing machines: a careful reading of the f-seriesreducing machine technical documents, an understanding of the operation and location of emergency parking units, an understanding of security initiatives and their location and utility. in the course of the use and maintenance of the f-seriesreducing machines, it is necessary to wear appropriate work clothes to prevent possible entanglement hazards, to wear safety belts when high-altitude homework is in danger of falling, to conduct preventive checks of chains, straps and accessories for lifting and transporting, to recommend, for specific manoeuvres, the use of auxiliary lighting and to perform specific manoeuvresGearbocUse of low-pressure compressed air to spray the f-series decelerator。

It is strictly prohibited to modify the plant ' s set-up or parts ' configuration by non-standard, non-purpose means. ban on f seriesGeared motorMobile areas for technical repairs, maintenance and adjustment. The non-f series ofreducing machines authorize staff to enter a machine-manufacturing area that is not authorized to do so, while the f series ofreducing machines do not authorize staff to enter a machine-manufacturing area that is not allowed to do so, and the movement of small barriers is prohibited. Prohibition of welding or the occurrence of arc light where welding signs are prohibited, in case of fire or explosive hazard. In the maintenance of mobile parts, any manipulation is prohibited. Before starting work, staff members should check that the f-seriesreducing machines have been powered out, with appropriate protective measures (warning signs, protective devices, etc. ) to prevent out-of-scope contact or movement of the machines at work, and that they must be careful and careful if they need to be wired to the electrical equipment. They must always work from a strict position. It is prohibited to use water to extinguish fire on electrical components. Whether or not to be around equipment with insufficient voltage. in front or somewhereInduction motora copy (in terms of guidance, adjustments, maintenance, etc.) requires timely access to safety manuals, mandatory use of protective gloves and eye protection measures (eye masks or masks). smoking is prohibited where there are signs prohibiting smoking in order to prevent fire or explosion. fire is prohibited where there are signs of a ban on ignition in order to prevent a fire or explosive hazard. http://boserlgearreducer.com/product/list-fxiliijiansuji-cn.html